DigiWeigh A12 Manual - Página 4

Procurar online ou descarregar pdf Manual para Balanças DigiWeigh A12. DigiWeigh A12 7 páginas.

In weighing mode, press [FUN] key to enter accumulating mode. Place the first item

onto the scale and wait until the STAB sign on. Press MOD key to store the weight

into memory. Remove the first item and place the second item onto the scale then

repeat the previous procedure. Maximum loads for one accumulating is 200.

Clear the scale platform and press [FUN] key to view the number of loads and total

weight. Press [ZERO] key to clear the memory.

2.6 WEIGHT HOLDING FUNCTION (WHEN F3 KEY=3)

Press [MOD] key to hold the readout, press [MOD] again to release.

2.7 PRE-TARE FUNCTION (WHEN F3 KEY=4)

Press [MOD] key to enter Pre-pare Setting. Press [ZERO] to move the editable digit

(blinking) and press [TARE] to change the value. Make the displayed value equal to the

container which needs to be tare for every load. Press [FUN] to confirm. The display

will show the negative number for tare value.

2.8 ANIMAL WEIGHING (WHEN F3 KEY=5)

Press [MOD] key to set parameters of animal weighing.

1. Stable time: "Fil

is the fastest and 5 is the lowest. Press [TARE] to select the desired value and

press [FUN] to confirm and move to the next parameter.

2. Display Range: "Rang

[TARE] to select the desired value and press [FUN] to confirm and move to the

next parameter.

3. Lock Range: If the change of weight exceeds the input value, the indicator will

refresh the display. Press [FUN] to confirm.

4. Press [FUN] to start animal weighing. Press [FUN] again to exit.

2.9 CHECK-WEIGHING

Check-weighing is a function to control the items to be weighed within or without the

pre-set range. If the high-limit and the low-limit are set as same value, the indicator will

set alarm for one key point. If the high-limit is set higher than the low-limit, the indicator

will set alarm for a weighing range.

To set check-weighing parameters: when the indicator is off, turn it on and press

[ZERO] key when the indicator is still warming up. You will see "F1CLK" on the screen.

Press [TARE] key 3 times and the screen will show "F4

enter beep mode setting:

Beep 1: No beep. When the weight is higher than the high-limit, HI will be on. When

the weight is lower than the low-limit, LO will be on. Otherwise both HI and LO will be

on.

Floor / Pallet Scale

n" (n value can be changed). "n" value options: 1/2/3/4/5. 1

n". "n" value options: 1/2/3. 2 is recommended. Press

CHK". Press [FUN] key to