Digizoid ZO2.3 Manual Smart Start - Página 2
Procurar online ou descarregar pdf Manual Smart Start para Amplificador Digizoid ZO2.3. Digizoid ZO2.3 4 páginas.
Imprimir páginaCHARGING
When the battery is low, a secondary red LED in the LightBar will blink.
•
To recharge the battery, connect the mini-end of the supplied USB charging cable to ZO's
•
charging port, and the other end to your computer's USB port.
When charging, the charge status indictor light will turn on. When fully charged, the light
•
will automatically turn off.
To properly maintain the battery, go through at least one charge cycle per month (fully
charge the battery, then let it completely drain).
CONTROLS
Powering On/Off
To turn ZO on, push in and release the switch. The LightBar will illuminate.
•
To turn ZO off, push in and hold the switch until the LightBar turns off.
•
Contour Profile Selection Mode
When turned on for the first time, ZO automatically goes into this mode, and the middle
•
contour profile is selected (orange LightBar).
ZO has 32 contour profiles for adjusting the sound characteristics of SmartVektor™
•
technology. To select other contour profiles, rotate the switch upwards or downwards (at
the minimum contour profile the LightBar is green, and the maximum profile is red).
The switch can select settings using single steps or by scanning. When the switch is
rotated briefly (< 1 sec.), settings are changed by one level/profile. When held rotated,
the switch scans through the settings.
Low / High Gain Selection Mode
In contour profile selection mode, push in and release the switch to enter gain select mode.
•
On first use, ZO will be set to high gain mode (pink LightBar). Since ZO's volume is fixed in
•
this mode, use the volume control on your audio source to adjust loudness.
To exit high gain mode and enter low gain mode, rotate the switch downwards (LightBar
•
will turn purple). ZO's volume will be at the maximum level.
High gain should only be used when connecting to the headphone out from your
audio source. If using a line-out dock, low gain mode should be used to adjust the
volume level, starting at the lowest volume level.
To adjust the volume, rotate the switch upwards or downwards (the intensity of blue
•
increases or decreases as volume level is raised or lowered).
To enter high gain mode, increase the volume to maximum (purple LightBar).Then, rotate
•
and hold the switch upward for approximately 3 - 5 seconds (or until the LightBar turns
pink).
To switch back to contour profile selection mode when in either low or high gain, push in
•
and release the switch.
Low gain mode is not recommended for use with a headphone out connection, as
the volume level may not be sufficient.