Acuity Brands Gotham SQAZ Instruções de instalação

Procurar online ou descarregar pdf Instruções de instalação para Racks & Stands Acuity Brands Gotham SQAZ. Acuity Brands Gotham SQAZ 2 páginas. Mounting frames

Imprimir página

INSTALLATION INSTRUCTIONS

SQF, SQAZ and SQHZ

Mounting Frames

Upon receipt, thoroughly inspect for any

freight damage which should be brought

to the attention of the delivery carrier. Com-

pare the catalog description listed on the

packing slip with the label on the carton to

ensure that you have received the correct

merchandise.

IMPORTANT SAFETY INFORMATION

For Your Protection, Read Carefully

WARNING: Risk of fire. Do not install

insulation within 3 inches of fixture sides

or wiring compartment, nor above the fix-

ture in such a manner as to entrap heat.

1. Electric current can cause painful

shock or serious injury unless handled

properly. For your safety, always

remember the following:

Turn off the power supply.

Ground the fixture to avoid poten-

tial electrical shocks.

Do not handle an energized fixture

or energize any fixture with wet

hands, when standing on a wet or

damp surface, or in water.

2. Specific safety information concerning

lamps:

Match wattage of fixture and lamp

exactly.

Do not remove or insert lamp when

power is on.

Do not scratch glass or subject lamp

to undue pressure as either may

cause lamp breakage.

Protect operating lamp from sources

of moisture.

If lamp is marked

it contains

mercury. Follow disposal laws. See:

www.lamprecycle.org.

SAVE THESE INSTRUCTIONS

Clamping

latch arms

Open

Closed

Figure 1

Bent tab

Channel

bar

Figure 2

Mounting

frame

Ceiling

Figure 3

Sight

Notches

Figure 4

Remove

knockouts

as needed

Figure 5

NEW INSTALLATION FOR SQ

Lay-in panel T-bar ceiling:

1. Cut ceiling opening slightly larger

than the outside diameter of the

mounting frame.

2. Position mounting frame through

opening in ceiling. Release clamp-

ing latch arms and adjust channel

bars to the correct spacing be-

tween T-bar as shown in Figure 1.

Secure channel bars to T-bar by

means of wire ties, screws or by

T-Bar

bending ends onto T-bar as shown

in Figure 2.

3. Once mounting frame has been

Wire tie

secured in structure, adjust the

mounting frame vertically to align

the bottom edge to either flush or

slightly above (1/8" max) the ceiling

line (Figure 3). Secure mounting

frame into position by closing the

clamping latch arm. The notch

located in the draw-down flange of

the housing can be used to assist

Flush or

slightly above

with alignment of multiple fixtures

ceiling line

(Figure 4).

4. If additional security is required, a

No. 8 sheet metal screw, wire tie or

wire (not supplied) may be used to

tie the latch arm to the mounting

frame as shown in Figure 1.

5. Remove knockouts on junction box to

feed power supply to fixture as

shown in Figure 5. Supply wire must

meet applicable electrical codes

and be rated for a minimum of 75

Junction box is thru-wire rated for 8-

No. 12 AWG conductors (4 in-4 out).

6. Complete necessary wire connec-

tions. Snap the door onto the junc-

tion box.

7. To adjust trim after installation, see

" Trim-Post Installation Adjustment."

CJ520004 Rev. B

1 of 2 6/10