DIGWDF ESP/XBee Snap-In Manual do utilizador - Página 7
Procurar online ou descarregar pdf Manual do utilizador para Adaptador DIGWDF ESP/XBee Snap-In. DIGWDF ESP/XBee Snap-In 9 páginas. Wireless adapter board
Imprimir página3.3vdc available, bypass the voltage regulator by soldering a jumper wire across the
regulator's pins 1 and 3.)
The pin 4 RX data connection is used ONLY when using the adapter as a standalone
transmitter and then only with an XBee radio. In a transmit mode, be sure to install the 3.3v
Zener diode, the 2-pin header and jumper shunt to protect the XBee radio's input. (Note:
there is no facility or circuitry for transmitting via an ESP8266 module.)
Using an ESP Snap-In adapter with the Snap-In
The DIGWDF ESP Snap-In was developed to plug directly into the two rows of female XBee headers
as a plug-in electrical replacement for an XBee radio with the understanding that the firmware and
network settings for ESP8266 operations are different and may require other firmware and/or
software modifications for successful operation. Note also that the ESP8266 module requires the
installation of the higher-current UA78M33 or LM1117T regulator in the XBee Snap-In.
DIGWDF XBee/ESP Snap-In Assembly & User Guide – v 20170308 -Page 7