DIHL KA-HWD01 series Manual do utilizador - Página 2
Procurar online ou descarregar pdf Manual do utilizador para Dispensador de água DIHL KA-HWD01 series. DIHL KA-HWD01 series 3 páginas. Hot water dispenser
Imprimir página
Introduction
Your new Dihl instant kettle allows you to make a
hot drink almost instantly. Read this user manual
carefully before you use the appliance and save it
for future reference.
Caution
1.
Read all instructions carefully before use.
2.
Before first use, check to ensure the voltage
indicated on the unit corresponds to the
voltage of your home.
3.
Do not operate the unit if the water is below
the minimum level as this will cause damage to
the heating element.
4.
Do not let the cord hang over the edge of a
table or counter, and keep away from hot
surfaces or naked flames.
5.
Do not put the appliance in the refrigerator.
6.
Do not lean the appliance or operate it upside
down.
7.
For indoor, domestic use only.
8.
This appliance is not intended for use by
persons with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their
safety.
9.
The unit is not intended to be operated by
means of an external timer.
10.
Keep away from children. Do not allow
children to play with the unit.
11.
To prevent electric shock or other injury, never
immerse the appliance in water or any other
liquid, nor rinse it under the tap.
12.
Do not touch the hot surface or water spout
when in use.
13.
Do not block the steam outlet or open the
water tank lid while the appliance is in use.
14.
Do not use the appliance to heat anything
other than water.
15.
Do not fill the water jug above the maximum
level.
Preparing for use
Place on a flat surface.
1.
Plug the unit into the mains and turn on the
2.
power switch. The red LED indicator will
illuminate.
3.
Clean thoroughly before first use.
4.
Fill the water tank and operate several times
before first use.
5.
Place a cup on the overflow tray and press
the 'ON' button. After a short period, the LED
will turn green.
Press the 'ON' button to dispense the water.
6.
Press the 'OFF' button to stop the flow of
water.
7.
The unit will cut out when there is insufficient
water. At this point the green LED indicator will
turn red. Turn off the power switch to
automatically prevent water from being
dispensed when the water tank is refilled.
When the water overflow tray is full, allow the
8.
water to cool before removing the tray and
pouring away. Always reattach the water
overflow tray before continuing use.
Cleaning
1.
Always switch off and unplug your water
dispenser and allow it to completely cool
before cleaning.
Do not immerse the unit in any liquid.
2.
3.
Wipe the outside of the appliance with a
clean, damp cloth.
4.
Clean the appliance with hot soapy water
and a non-abrasive sponge.
To maintain performance, descale the
5.
appliance monthly. To do this, add some
detergent to hot water and operate the unit
at least three times. Rinse thoroughly with
clean water before using again.
6.
To clean the reservoir, remove the rubber
stopper plug at the base of the unit and
empty any residue water. Wash with a clean,
damp cloth and replace the rubber stopper
securely before reusing.