EPSON Stylus COLOR 660
Safety Approvals
Safety standards
UL 1950 with D3, CSA C22.2 No. 950
with D3
EMC
FCC part 15 subpart B class B, CSA
C108.8 class B
Parallel Interface
Forward channel
Data format
8-bit parallel, IEEE-1284 compatibility
mode
Synchronization
STROBE pulse
Handshake
BUSY and ACKNLG signals
timing
Signal level
TTL compatible
Connector
57-30360 Amphenol connector or
equivalent
Reverse channel
Transmission
IEEE-1284 Nibble mode
mode
Adaptable
57-30360 Amphenol
connector
connector or equivalent
Synchronization
Refer to the IEEE-1284 specification
Handshaking
Refer to the IEEE-1284 specification
Signal level
IEEE-1284 Level 1 device
Data transmission Refer to the IEEE-1284
timing
specification
Control Panel
paper out light
black ink
out light
color ink
cleaning
out light
button
4 - EPSON Stylus COLOR 660
load/eject
power light
button
power
button
The four lights on your printer's control panel show the
printer's status and alert you to problems like paper jams.
P
The power light is on when the printer is on and
ready to print. The power light flashes when the
printer is receiving a print job, charging ink, or
cleaning the print head.
B or A When an ink out light flashes, your ink supply is
low. Make sure you have a replacement cartridge.
When an ink out light comes on, you need to
replace the ink cartridge. See "Replacing an Ink
Cartridge" on page 6 for instructions.
S
When the paper out light comes on, your paper ran
out or is incorrectly loaded. Make sure none of the
sheets are curled, creased, old, stuck together, or
too thin. Reload the paper against the right edge
guide and slide the left edge guide over to the
paper's left edge. Then press the E load/eject
button to resume printing.
When the paper out light flashes, you have a paper
jam. Turn off the printer and gently pull out all
paper. Make sure none of the sheets are curled,
creased, old, stuck together, or too thin. Reload
the paper against the right edge guide and slide the
left edge guide over to the paper's left edge. Then
turn the printer on.
P S
When the Ppower and S paper out buttons flash
and the B black and A color ink out lights come
B A
on, jammed paper may be blocking movement of
the print head. Turn off the printer (press the
P power button); wait 15 seconds; then turn it on
again. If this does not clear the error, contact your
dealer or EPSON as described in the Printer Basics
book.
When all the lights flash, your printer may have an
internal error. Make sure you removed all the
packing materials as described on the unpacking
sheet in the printer box. Turn off the printer (press
the P power button); wait 15 seconds; then turn it
on again. If this does not clear the error, contact
your dealer or EPSON as described in the Printer
Basics book.
When all the lights are off, the printer is not
receiving power. Try these solutions:
Make sure the printer is turned on.
Turn off the printer, plug in the power cord
securely, and turn on the printer.
Make sure the outlet is operable and is not
controlled by a switch or timer.
Try using another outlet.
8/99
Imprimir página