Epson Stylus COLOR 860 Informações sobre o produto - Página 5

Procurar online ou descarregar pdf Informações sobre o produto para Acessórios para impressoras Epson Stylus COLOR 860. Epson Stylus COLOR 860 12 páginas. Product support bulletin(s)
Também para Epson Stylus COLOR 860: Ficha de informação do produto (4 páginas), Especificações (2 páginas), Substituição de cartuchos (2 páginas), Ficha de informação do produto (4 páginas), Boletim de apoio ao produto (6 páginas), Boletim de apoio ao produto (1 páginas), Boletim de apoio ao produto (3 páginas), Boletim de apoio ao produto (2 páginas), Boletim de apoio ao produto (4 páginas), Boletim de apoio ao produto (7 páginas), Manual de configuração (17 páginas)

3. Lift up the two ink cartridge clamps.

4. Unwrap the ink cartridges, then remove only the yellow

part of the tape seal on the top. Don't pull off the blue part.

black cartridge

5. Insert both ink cartridges with the labels facing up as

shown. Press down the clamps until they lock into place,

but don't press down on the ink cartridges.

6. Press the R cleaning button and close the printer cover.

Ink charging takes about two minutes, with the P power

light flashing and the printer making noise until it's finished.

Don't turn off the printer or interrupt charging or it will start

over, using more ink than necessary. It's finished when the

P power light stops flashing.

color cartridge

Testing the Printer

You can run a printer check to determine whether a problem

comes from the printer itself or some other source. Follow

these steps to run the printer check:

1. Make sure both the printer and computer are turned off.

2. Disconnect the interface cable from the printer.

3. Make sure paper is loaded in the printer.

4. Hold down the E load/eject button, then press and release

the Ppower button. Continue holding down the

E load/eject button until the P power light starts to flash,

then release it.

The printer prints one page showing its ROM version

number, ink counter, and a nozzle check pattern. Only the

nozzle check pattern is shown below. (If the pattern has

gaps in its dots, you need to clean the print head; see

page 9.)

5. To end the check, turn off the printer after it prints the

check page. Then reconnect the interface cable and turn on

your printer and computer.

If the check page prints, the problem probably lies in your

software settings, the interface cable, or your computer.

If the check page doesn't print, you may have a problem with

your printer.

Try the suggestions in "Problems and Solutions" in the Printer

Basics book.

8/99

EPSON Stylus COLOR 860

- 5