Dillon Precision Products RL 550B Manual de instruções - Página 15

Procurar online ou descarregar pdf Manual de instruções para Equipamento industrial Dillon Precision Products RL 550B. Dillon Precision Products RL 550B 18 páginas.

Imprimir página

will do, but without this problem. Warning: Do not

use I.M.R. pencil lead type powder in cases smaller

than .30 caliber.

Problem 3. Primer jams or misfeeds.

A. Primer misfeeds can be caused by

misadjustment of the set screw (#13961) in the primer

feed block, Fig. 12.

B. The most common cause of primer misfeeds or

jams is the primer punch not seated fully into the

primer slide. This will cause the primer seating cup to

strike the flexible orifice on the bottom of the primer

magazine tube.

Warning: If the primers are jammed and will not

feed from the bottom of the primer magazine, Do Not

Attempt to force the primers or the primer slide. An

explosion resulting in injury may occur.

C. Another common problem is that the primer

slide fails to return fully forward with the new primer.

Periodically wipe the primer slide with rubbing

alcohol. This removes the spent primer residue that

causes the slide to drag.

Problem 4. Crushing cases:

A. If your dies do not have a radiused lead-in you

must guide the cases into the die. The best solution is

to replace the offending dies with dies having the

proper radius.

B. Always tighten your die lock rings with a case in

the die. This will assure you of proper alignment

between the die and the shellplate. Adjust your

depriming stem in the same manner and it will always

be on center.

REMEMBER

Be sure to use the necessary precautions when

loading lead bullets or when casting lead bullets.

Exposure to lead can cause cancer, birth defects, and

reproductive problems. Be sure to wash your hands

thoroughly after handling lead. When firing lead

bullets, be sure that you have adequate ventilation.

Keep any lead items out of reach of children.

Press forward firmly on the handle once it is at the

aft position to seat your primers fully.

Watch the powder bar function to make sure you're

getting powder.

Set the bullet straight on the case at Station Three so

that it enters the die correctly.

Watch your supply of powder, you'll be using it

faster than you think you are.

Take your time and learn the machine and its

function. The RL 550B will deliver hundreds of trouble

free rounds in short order, just relax and take your

time in the beginning.

Keep it clean – primer residue, spilled powder and

just plain dirt can jam your machine.

Clean your powder bar about every 500 rounds.

Some powders build up and will eventually stick the

powder bar. Paint thinner, acetone or lacquer thinner

works well to remove any build up.

NOTICE

This machine is designed specifically to be a

manually operated handloading machine. Any

attempts to automate this product will void any and all

warranties offered by the company. We specifically

warn against converting this product to automated or

motorized operation.

All Dillon machines are warranted for life from

defects in material or workmanship, plus a one year

100% warranty against normal wear. All

electrical/electronic components in Dillon equipment

are covered by a one year warranty.

* Indicates a caliber specific part. See the caliber conversion

chart on page 16 for the caliber you are loading for.