Epson ActionPC 7000 Series Manual de informações do produto - Página 10

Procurar online ou descarregar pdf Manual de informações do produto para Ambiente de trabalho Epson ActionPC 7000 Series. Epson ActionPC 7000 Series 11 páginas. Product information guide

Imprimir página

EPSON ActionPC/ActionTower 7000 series (including ActionTower 8400)

Tested Operating Environments

The following operating environments have been tested for

compatibility with the system.

Microsoft MS-DOS 3.3 and later

Novell DR DOS

Novell NetWare* 3.12 and 4.02

Novell Personal NetWare

IBM OS/2 including version 3.0 (Warp)

SCO UNIX

SCO Open Desktop

Microsoft Windows 3.0 and later

Microsoft Windows for WorkGroups

Microsoft Windows NT, including version 3.5

Microsoft Windows 95

* Certified as workstation; tested as file sewer

Your system has also received Novell's "Yes, NetWare tested

and approved" certification as a workstation. As new

environments become available, these also will be tested.

Installation/Support Tips

Installing Diskette Drives

and that the drive is enabled in the SETUP program.

diskette drive controller.

Installing Hard Disk Drives

If you are installing a drive that cannot use the embedded

IDE interface (such as an ESDI drive), it is recommended

that you use a 16-bit, AT-type hard disk controller. If you

install a non-IDE hard disk drive and controller card, you

must set jumper JP5 to On to disable both of the built-in

IDE hard disk drive interfaces. Also, remove the hard disk

drive ribbon connector from the system board.

When installing a hard disk drive, use the auto-sensing

feature in SETUP to select the correct type for the drive. If

the auto-sensing feature does not produce a match for the

drive, you can define your own drive type by selecting

User as the type and entering the drive's parameters.

Software Problems

try the installation at high speed. If this does not work

properly, select low speed by pressing Ctrl Alt - (on the

numeric keypad). Try loading the program at low speed

and then switching to high speed, if possible.

its copy-protection method, try loading it at high speed. If

this does not work, load it at low speed.

10 - ActionPC/ActionTower 7000 series (including ActionTower 8400) 10/30/95

Installing Option Cards

If you are installing a video adapter card, make sure you

disable the built-m VGA controller by setting JPl5 to 2-3.

Upgrading the Processor

When you replace the processor, you need to check the

settings of several jumpers, as listed on page 3.

Booting Sequence

If you cannot boot the computer from the hard disk, make

sure the booting sequence in SETUP is set to

Then boot the computer from a system diskette in drive A.

Password

If you forget your password, you must discharge your

CMOS memory as follows:

Turn off the computer and remove the cover.

Disable the password by setting jumper JP11 on the main

system board to On.

Turn the computer on, leave it on for a few seconds, then

turn it off again.

Set jumper JP11 back to off to select the system board

battery.

Run SETUP to enter a new password, if desired.

Information Reference List

Engineering Change Notices

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.