ABB Dodge SCXT205 Manual de instruções - Página 2
Procurar online ou descarregar pdf Manual de instruções para Accionamentos DC ABB Dodge SCXT205. ABB Dodge SCXT205 16 páginas. Screw conveyor and hydroil screw conveyor drive
OPTIONAL ADJUSTABLE PACKING
ADAPTER – ASSEMBLY
1.
Place reducer on blocks so that it lays flat with the input
shaft down.
2.
Position adapter on reducer output hub so that small end
(end with 12 holes) rests on reducer. Select the 4 mounting
holes to match the shaft used (Figure 1).
3.
Place adapter screws and lockwashers through adapter
and thread into reducer. Do not tighten.
4.
Install 2 screws in studs in the adapter. Use Loctite on
threads. See Figure 2.
Flatten braided seals with a soft hammer. Place seals in
adapter, one of top of the other with joints offset from each
other. Lay retaining ring loosely on top of seals. Slide shaft,
keyseated end first, into adapter and through adjusting
flange into reducer. Take care to clear the seals with the
adapter section of the shaft. Once shaft has bottomed,
seat retainer ring by tapping with a hammer. Install
adjustable flange and secure with hex nuts provided.
5.
Carefully place reducer on its side. Rotate shaft to align
keyseats in shaft and output hub and install key. Install shaft
retainer, lockwasher, and bolt. Tighten bolts per Table 4.
6.
Lay reducer on blocks with input shaft down and tighten
adapter bolts per Table 4.
LIP SEAL OR
FELT SEALS
SEAL
RETAINING
RING
DRIVE
SHAFT
SCREW CONVEYOR DRIVE
SPEED REDUCER
ADAPTER
ADAPTER BOLT
AND LOCK WASHER
Figure 2- Optional Adjustable Packing Adapter
Adjustable
Flange
Hex
Nut
Figure 1 - Assembly
DRIVE SHAFT
2
Adjustable
Packing
Adapter
SHAFT
RETAINER
KEY
RETAINER BOLT
AND LOCK WASHER
Screw
Stud
Retainer
Ring
Braided
Seals
Drive
Shaft