Motorola XU2100 - XTN Series UHF Manual do utilizador - Página 18
Procurar online ou descarregar pdf Manual do utilizador para Rádio bidirecional Motorola XU2100 - XTN Series UHF. Motorola XU2100 - XTN Series UHF 35 páginas. Xtn series
Também para Motorola XU2100 - XTN Series UHF: Manual do utilizador (15 páginas)
Programming the Interference Eliminator Code
The Interference Eliminator Code helps minimize interference by
providing you with code combinations, which filter out static, noise,
and unwanted messages.
1. Enter Programming Mode as necessary, refer to "Entering
Programming Mode" on page 31.
2. Press \ until the Interference Eliminator Code display number
begins to flash.
3. Press [ or ] to select the desired Code (See "Interference Eliminator Codes"
beginning on page 48).
4. Press and hold M to exit k, or press \ to continue.
Assigning Channels to Presets (XU2600 and XV2600 only)
Presets allow you to easily switch to more frequently-used channels.
1. Enter Programming Mode as necessary, refer to "Entering Programming Mode"
on page 31.
2. Press [ or ] to select the desired channel.
3. Press and hold T or S to assign that channel to a preset, radio beeps to
confirm. All of the channel settings are assigned to that preset button.
4. Press and hold M to exit k, or press \ to continue.
Programming the Scramble Feature
(2-watt models only)
The scramble feature garbles the transmission for anyone listening without
the same scramble setting. It does not guarantee confidentiality, but it increases
privacy. The scramble feature is set individually for each channel.
1. Enter Programming Mode as necessary, refer to "Entering Programming Mode"
on page 31.
2. Press \ until e displays.
3. Press [ or ] to select
When you exit k, e displays.
4. Press and hold M to exit k.
Programming Bandwidth (when FCC allowable)
Some frequencies have selectable channel spacing, which must
match other radios for optimal radio quality. Bandwidth settings are
programmed for each channel.
1. Enter Programming Mode as necessary, refer to "Entering
Programming Mode" on page 31.
2. Press \ until K displays.
3. If D/C flashes, press [ or ] to select D (25.0 kHz) or C (12.5 kHz)
bandwidth. (See "Frequencies and Bandwidths" beginning on page 45). If D/C
X
does not flash, then you cannot select the bandwidth for this frequency.
34
,
, or
. Factory default is set to Off: 0.
1
2
3
Interference
Eliminator
01075
Code
X
33
e 0
C
K