ARGSeguridad L100II Instruções de instalação - Página 2

Procurar online ou descarregar pdf Instruções de instalação para Por fechaduras ARGSeguridad L100II. ARGSeguridad L100II 2 páginas.

New Door Preparation

1 Mark Door

Select 2 3/8'' or 2 3/4''(60mm or 70mm）

from backset and mark center of hole on

door face. And two holes for fixed lock

body.

2 Drill Holes

Dirll 2 2/7'' (58mm) hole on door

face. Drill 1 1/40'' (26mm) hole in

door edge for the latch strip. And

two 5/18'' (7m) holds.

3 Install Latch

1) Insert latch strip in the hole and

keep it parallel to door face. Mark

outline of face plate and remove

latch.

2) Chisel 1/8''(3mm) deep or untill face

plate is fill with door edge.

3) Inter latch and tighten screw.

4 Verify Backset

1) The backset is a distance from door

edge to center of hole on door face.

2) All locks are supplied with adjustable

latches which fit 2 3/8'' or 2 3/4''(60mm

or 70mm) backsets.

(Templates provided)

5 Adjust Latch's Backset

The left of adjustment hole

The backset is at the 2 3/8''(60mm) position,

when the product is shipped from the facory.

The clip of regulator pin

Regulator pin

Pull

Pull regulator pin to the right edge.

The right edge of adjust hole

The backset has been adjusted to 2 3/4'' position.

Make sure the regulator pin is at the correct angle as

shown.

Regulator pin

Screw-post hole