Motorola GM1200E Manual de instalação - Página 27
Procurar online ou descarregar pdf Manual de instalação para Rádio Motorola GM1200E. Motorola GM1200E 36 páginas. Dealer programming software dps
Também para Motorola GM1200E: Manual do utilizador (22 páginas), Manual de instalação (8 páginas)
Imprimir página3.0
Operation of a Conventional Ignition System
To effectively reduce ignition interference in a vehicle, it is well to understand the operation of an
automobile ignition system.
Ignition is necessary in a gasoline engine to ignite the gasoline vapour and the air mixture in its
cylinders. The system is made up of the battery, distributor, breaker points, coil, condenser, and
spark plugs. The battery is the only electrical source of power in an automobile, so the lower battery
voltage must be stepped up to the high voltage necessary to arc across the spark plug electrodes.
This arc ignites the gas mixture.
In the conventional ignition system (Figures 2-2) a mechanical circuit breaker (the cam and points in
the distributor) opens the primary circuit of the ignition coil, and high voltage is developed at the
secondary. This high voltage is synchronized and applied to each spark plug by the distributor.
Ignition
Switch
Battery
Figure 2-2 Typical Vehicular Ignition System, Simplified Schematic Diagram.
The battery is connected to the primary winding of the coil through the ignition switch. The primary
circuit is returned to the battery through the breaker points, which are bypassed by the condenser.
The points are normally closed. As the cam shaft is rotated by the engine, its lobes or corners open
and close the points in proper synchronisation with the piston in each cylinder.
Reducing Noise Interference in Mobile Two-Way Radio Installations
Breaker
Points
Cam
Condenser
Breaker
Ignition
Points
Switch
Cam
Battery
Operation of a Conventional Ignition System
HV Lead
Distributor
Ignition
Coil
Rotor Gap
Ignition
Coil
Stray
Capacitance
Condenser
Spark plug
leads
Spark
plugs
Lead Inductance
Spark Plug Gap
2-3