Motorola T3 Manual do utilizador - Página 22

Procurar online ou descarregar pdf Manual do utilizador para Rádio Motorola T3. Motorola T3 50 páginas. User guide
Também para Motorola T3: Manual de início rápido (2 páginas), Brochura (2 páginas), Manual (38 páginas)

Imprimir página

1. T3 Powerbroadband Switch

System Administration

T3 Firmware

T3 Switch stores one active and one alternate boot image.

To view the current image, or to monitor the progress of an upgrade, use:

show system image

The system image can be upgraded using FTP or TFTP. Commands used are:

Using FTP:

system image load ftp://username:password@ipaddress/path/t3-app.img

Using TFTP:

system image load tftp://ipaddress/path/t3-app.img

Instructions to obtain and upgrade the system image are found in the release notes of each software image.

Ethernet WallPlate Firmware

The Ethernet WallPlate software image is embedded in the T3 system image. As of the T3 3.0.0 firmware

release, no upgrade is required on the Ethernet WallPlates. Check the most current firmware Release Notes to

see if an image upgrade will be done on the WallPlate.

At bootup, the image version is checked. If the WallPlate image requires a reload, the time to upload all 25

WallPlates is approximately 20 minutes. Interruption during the upgrade time will not damage the WallPlate.

Note, however, that the Ethernet WallPlate will be unable to carry network traffic during image upgrade.

Wireless WallPlate Firmware

The Wireless WallPlate software image is stored in the file system of the T3 Switch and loaded onto the

WallPlates from that location. Each Wireless WallPlate stores one active and one alternate image. The image

can be upgraded in runtime, user traffic will not be affected. The total time to complete a runtime upgrade of any

single WallPlate is approximately 20 minutes. If upgrading multiple WallPlates, the system will automatically

stagger the start-time of each unit. Monitor the upgrade process using this command:

show remote image

The status will display a percentage of completion, and show what action is currently being done. Do not reboot

the WallPlate until it is 100% complete. Since the WallPlate supports two images, an unintentional interruption

will not damage the unit.

Upgrading the software on the Wireless WallPlate requires three steps:

Step 1: FTP or TFTP the Wireless WallPlate image to the file system of the T3 Switch

file copy tftp://<IP of TFTP server>/path/mc800-app.img to mc-800-app.img

NOTE: do not change the name of the file.

Step 2: Load the new image into the alternate image bank on the Wireless WallPlate

remote image load port<x> tftp://<Private IP address of T3>/mc800-app.img

NOTE: for information on IP Addressing refer to pages 24-26, "Managing the Wireless WallPlate"

Step 3: Reboot the Wireless WallPlate to activate the new software

remote image boot port<x> alternate

remote reboot port<x>

Motorola, Inc.

570510-001-00 rev A

Page 22 of 50