Epson TM-L90 series Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Fabricante de etiquetas Epson TM-L90 series. Epson TM-L90 series 12 páginas. Attaching cover on the power switch
Também para Epson TM-L90 series: Brochura (1 páginas), Brochura (2 páginas), Especificações (2 páginas), Especificações (8 páginas), Manual de informações (5 páginas), Especificações (4 páginas), Manual do utilizador (17 páginas), Começar aqui (2 páginas), Começar aqui (2 páginas), Manual (13 páginas), Manual (2 páginas)

How to connect an Epson wireless POS printer

setting

Use WEP

key

WEP Key

Channel

Configuring a Computer or Router

There is no way to change the settings on the wireless adapter directly. You first must connect to a computer and then

change any settings using the

wireless settings to work with the adapter to make changes on the wireless adapter to work on your network. After the

changes are made you can reset your network to its original settings.

Tip: It may be less disruptive to configure the wireless adapter using a different computer or network from the one it is to

be installed on.

The wireless adapter defaults to Ad-Hoc mode, with a SSID of EpsonNETIBSS, IP address of 192.168.192.168 and no

encryption.

Configuring a Wireless Router

If you are using a wireless router to connect with the printer:

Configuring a Computer with a Wireless Adapter

If you are using a wireless adapter installed in a computer to connect with the printer:

1. Install the wireless adapter on the computer if not already installed

2. Change the wireless adapter to Ad-Hoc. Open up the Wireless Adapter tab and press Advanced. Then change the

3. Open the Wireless Adapter Properties in the Network Connections of the Windows Control Panel. If the first three

http://www.beaglehardware.com/howtowireless.html[3/4/2011 12:28:11 PM]

Manual

None

Epson TMnet

Select AD-Hoc mode

Set the subnet to work in the address range of the wireless adapter (192.168.191.xxx if using default value)

Make sure the wireless broadcast is on

Turn off encryption or WEP

Turn off firewalls and filtering

Networks to access to ad-hoc.

numbers of your IP Address are 192.168.192 (assuming the wireless adapter is set at the default IP address of

192.168.192.168) then you do not need to reconfigure your computer's IP Address. If the first three numbers of

IP addresses are assigned on your network.

None / 64-bit / 128-bit

set this if key is used

Channels 1-11. When using Ad-Hoc mode,

set

the channel directly. When using in the

infrastructure mode, it is set automatically.

utility. This means that you must modify your computer's or router's