AEMC instruments L452 Manual de início rápido - Página 11
Procurar online ou descarregar pdf Manual de início rápido para Registadores de dados AEMC instruments L452. AEMC instruments L452 17 páginas.
Imprimir páginaStarting a Recording Session
You can start a configured recording session immediately or schedule one for a later
date and time. To start a recording immediately:
1. At the "home" screen, press ► to display the Recording and Duration screen.
The Duration field on this screen specifies the length of the recording session. By
default (assuming no session has been already scheduled), this is 15 minutes.
The Duration setting cannot be shorter than the Storage Period setting.
2. To change the duration setting, press
select the Duration field. Then, press
enter a duration period.
For example, to change the duration from 15 minutes to 3 days, select the "1" in
"15 min" and press
press ► to highlight the number "5." Press ▼ twice to change this to "3." Finally,
press ► to select the units and use the ▲ and ▼ buttons to cycle through the
available choices. These include s (seconds), min, hours, days, and weeks. Select
"days" and press
field you can use the Stop Date and Stop Time screen to determine how long the
recording session will run.
3. To start the recording, press
immediately using your specified configuration settings. The recording session will
end when the time interval defined by the Duration field ends.
When a recording is active, the Recording icon
icon bar at the top of the scree. If you attempt to turn OFF the instrument by pressing
while a recording is in progress, the message RECORDING ACTIVE will appear on
the screen. The
Scheduling a Recording Session
Instead of starting a recording immediately, you can schedule a recording for a future
date and time. You can only schedule one recording at a time. To schedule a new
recording, the active recording must run to completion, or you must cancel the earlier
recording.
1. At the "home" screen, press ► to display the Recording and Duration screen.
2. Press ▼ twice to display the Start Date/Time screen.
3. Press
twice. The first number under Start Date will be highlighted. Use the ▲
and ▼ buttons to increase or decrease the number and the ► and ◄ buttons to
move from one field to the next. If you press ► when the last number in the Start
Date field is selected, the selection will move to the first number in the Start Time
field. This will enable you to edit both the date and time in a single editing session.
When you have finished entering the start date and time, press
changes.
to begin edit mode. Use ▼ to change this to a zero. Then,
to save your change. Alternatively, instead of the Duration
button is disabled while a recording is in progress.
to initiate selection mode and press ▼ to
to start edit mode and use the buttons to
three times. The recording session will start
will appear as a solid circle in the
to save your