Epson 1640XL - Expression Graphic Arts Manual - Página 13

Turn on the scanner by pressing the

While the scanner initializes, the fluorescent lamps on the carriage flash. If the carriage

is not at the home position (the left of the scanner), it moves to the home position.

When the scanner has completed its initialization, the READY light comes on. If the

scanner does not work as described, turn it off. Make sure that the power cord is firmly

plugged in and that you have released the transportation lock screw, then turn it on again.

Caution:

Whenever you turn off the scanner, wait at least 10 seconds before turning

it back on. Rapidly turning the scanner on and off can damage the scanner.

Connecting the Scanner to Your Computer

Connecting the Scanner to Your Computer Using the SCSI

Interface

For instructions on connecting the scanner to your computer using the SCSI interface,

read this section.

Note for Macintosh Users:

Be sure to install the scanner software before connecting the scanner to your computer.

See Chapter 3, "Installing the Scanner Software for Macintosh" in your online Setup

Guide for details.

For PC users:

Unless your PC already has a SCSI board installed, you need to install one, along with

SCSI driver software. Install the SCSI board according to the directions included with it.

Connecting the Scanner to Your Computer

OPERATE button.