Epson 2000P - Stylus Photo Color Inkjet Printer Informações sobre o produto - Página 5

Procurar online ou descarregar pdf Informações sobre o produto para Software Epson 2000P - Stylus Photo Color Inkjet Printer. Epson 2000P - Stylus Photo Color Inkjet Printer 13 páginas. Product support bulletin(s)
Também para Epson 2000P - Stylus Photo Color Inkjet Printer: Manual de configuração (17 páginas), Substituição de cartuchos (2 páginas), Boletim de apoio ao produto (6 páginas), Boletim de apoio ao produto (1 páginas), Especificações (1 páginas), Manual do utilizador (12 páginas), Boletim de apoio ao produto (3 páginas), Boletim de apoio ao produto (2 páginas), Boletim de apoio ao produto (4 páginas), Boletim de apoio ao produto (7 páginas), Manual de início rápido (2 páginas), Manual de instruções de instalação (8 páginas)

Imprimir página
Epson 2000P - Stylus Photo Color Inkjet Printer Informações sobre o produto
2. Lift up the two ink cartridge clamps.
3. Unwrap the ink cartridges, then remove only the yellow
part of the tape seal on top.
black ink
color ink
cartridge
cartridge
4. Tilt each cartridge forward slightly as you lower it into its
holder. Hang the tabs at the back of the cartridge on the
hooks on the holder clamps.
tabs
hooks
Don't place the cartridges under the holder clamp; you
may damage the clamp when you close it.
5. Close the ink cartridge clamps. (The color clamp is a bit
harder to close.)
6. Press the yellow ink cartridge replacement button (shown in
step 1) and close the printer cover.
Ink charging takes about three minutes, with the P power
light flashing and the printer making noise until it's finished.
Don't turn off the printer or interrupt charging or it will start
over, using more ink than necessary. It's finished when the
P power light stops flashing.

Testing the Printer

You can run a printer check to determine whether a problem
comes from the printer itself or some other source. Follow
these steps to run the printer check:
1. Make sure both the printer and computer are turned off.
don't touch the
2. Disconnect the interface cable from the printer.
green chips
3. Make sure letter-size or larger paper is loaded in the printer.
4. Hold down the E load/eject button, then press and release
the Ppower button. Continue holding down the
E load/eject button until the Ppower light starts to flash,
then release it.
The printer prints one page showing its ROM version
number, ink counter, and a nozzle check pattern. Only the
nozzle check pattern is shown below. (If the pattern has
gaps in its dots, you need to clean the print head; see
page 9.)
5. To end the check, turn off the printer after it prints the
check page. Then reconnect the interface cable and turn on
your printer and computer.
If the check page prints, the problem probably lies in your
software settings, the interface cable, or your computer.
If the check page doesn't print, you may have a problem with
your printer.
Try the suggestions in "Problems and Solutions" in the Printer
Basics book.
6/00
EPSON Stylus Photo 2000P
The printer's first ink cartridges won't last as long as the
replacements. This is because the printer uses more ink
when charging the print head for the first time.
EPSON Stylus Photo 2000P
- 5