Philips 15PT2967 Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para TV Philips 15PT2967. Philips 15PT2967 18 páginas. 15" real flat tv with crystal clear
Também para Philips 15PT2967: Ficha de especificações (3 páginas), Ficha de especificações (2 páginas)

Imprimir página

L01_15524 (GB) 1-1_190705

Remote control keys

Screen information / permanent no.

To display / clear the program number, name (if it

exists), time, audio mode and time remaining for the

sleep feature. Press the key for 5 seconds to activate

permanent display of the number.This key is also

used to exit from the menu.

Surround Sound (only available on certain versions).

To activate / deactivate the surround sound effect.

In stereo, this gives the impression that the

speakers are further apart. For models equipped

with Virtual Dolby Surround*, you can experience

Dolby Surround Pro Logic sound effects. In mono, a

stereo spatial effect is simulated.

VCR key *

Pre-set sound

Used to access a series of stored settings:

and return to

Music

Theatre

To call up or exit the menus.

Cursor / Format

These 4 keys are used to navigate through the

menus.The

keys are used to enlarge or

compress the picture vertically.

Volume

To adjust the sound level.

Mute

To mute or restore the sound.

Number keys

Direct access to the programmes. For a 2 digit program,

enter the 2nd digit before the dash disappears.

Selection of EXT socket

Press several times to select EXT1, EXT2, S-VHS

and AV.

Radio / TV mode

To switch the TV set to radio or TV mode (for

versions equipped with radio).

* VCR key

The remote control lets you control the main functions of the VCR.

Press and hold down the VCR key located on the side of the remote control, then press one of the keys to access

the VCR functions:

The remote control is compatible with all VCRs using the RC5 standard.

Safety Information

•

Plug the TV into a 220V – 240V AC, 50 Hz supply.

•

Disconnect mains plug when :

– the red light below the TV screen is flashing continuously.

– a bright white line is displayed across the screen.

– there is a lightning storm.

– the set is left unattended for a prolonged period of time.

•

Cleaning the TV screen. Never use abrasive cleaning agents. Use a slight damp chamois leather or soft cloth.

•

No naked flame sources, such as lighted candles, should be placed on top of the TV or in the vicinity.

•

Do not place your TV set under direct sunlight or heat.

•

Do not cover or block the TV as it could lead to overheating.

•

Leave at least 5 cm around each side of TV set to allow for proper ventilation.

•

Avoid placing your set (e.g. near the window) where it is likely to be exposed to rain or water.

•

Battery Usage CAUTION – To prevent battery leakage that may result in bodily injury, property damage, or

damage to the unit:

– Install all batteries correctly, with + and – aligned as marked on the unit.

– Do not mix batteries (old and new or carbon and alkaline, etc.).

– Remove batteries when the unit is not used for a long time.

Useful Tips

•

Do not leave your set on standby mode for a prolonged period of time. Switch off set to allow it to be

demagnetised.A demagnetised set supports good picture quality.

•

Do not shift or move the set around when it is switched on. Uneveness in colour in some parts of the screen may

occur.

•

Never attempt to repair a defective TV yourself.Always consult a skilled service personnel.

7/19/05

3:55 PM

Page 3

(

)

Speech

Personal

Standby

Lets you place the TV set on standby.To turn on the

TV, press

(or

Teletext keys (p. 8), VCR keys (p.11) and list of

radio stations

(p. 5)

Sleep

To select an automatic standby after a preset time

(from 0 to 240 minutes).

Format

To enlarge or compress the picture vertically

Pre-set image

Used to access a series of stored settings:

and return to

Natural

Soft

Multimedia

Teletext (p. 8)

Program selection

To access the next or previous programme.The

number, (name) and sound mode are displayed for a

few moments.

For some programs, the title of the program will be

displayed at the bottom of the screen.

Teletext keys (p.8)

or VCR keys *

Sound mode (only available on stereo versions)

Used to force programmes in

Stereo

for bilingual programs, to choose between

. For TV sets equipped for Nicam reception,

Dual II

depending on the programmes, you can force the

sound to

or select between

Stereo Nicam

Mono

and

Nicam Dual I

Nicam Dual II

The

indication is red when in forced position.

Mono

* "Dolby" and the double-D symbols

of the Dolby Laboratories Licensing Corporation.

Manufactured under license of Dolby Laboratories

Licensing Corporation.

Rich

Personal

or,

Mono

Dual I

Mono

are trademarks