Epson Endeavor WG Manual - Página 8

Procurar online ou descarregar pdf Manual para Software Epson Endeavor WG. Epson Endeavor WG 9 páginas. Using with ms windows 3.x stylus 400/800+/color printer driver
Também para Epson Endeavor WG: Boletim de apoio ao produto (15 páginas), Boletim de apoio ao produto (17 páginas), Boletim de apoio ao produto (3 páginas)

Imprimir página

EPSON Endeavor WG

If the computer has an Epson 120MB or 240MB hard disk

drive, select the appropriate type number from the table

below.

Epson Hard Disk Drive Types

Type number

Epson hard disk drive

120MB

240MB

Installation/Support Tips

Power

The computer has an input voltage selection switch on the

back panel to select between 115V, for USA and Canadian

use, and 230V, for use in other countries.

Mouse and Keyboard

When connecting the mouse and keyboard to the computer,

be careful to plug them into the proper ports. Although the

ports are physically identical, they are not interchangeable,

and you can damage the main system board if you plug the

connectors into the wrong ports.

Installing Diskette Drives

Make sure that the drive type has been correctly selected in

the SETUP program.

Installing Hard Disk Drives

Cl It is recommended that a 16-bit, AT-type hard disk

controller be used if

you

use the embedded IDE interface. If you install a non-IDE

hard disk drive and controller card, you need to use the

SETUP program to disable the built-in IDE hard disk drive

interface.

See the hard disk drive type tables on page 7 and use the

SETUP program to enter the correct type number(s) for

the hard disk drive(s) installed in the computer. (Also be

sure to use the SETUP program to set the hard disk drive

configuration if you install or remove a hard disk drive.)

You can select a type number that matches the parameters

for the drive or a type number with parameters having

lesser values, as long as they do not exceed the maximum

capacity (in MB) of the drive. If there is no match for the

drive, you

press

can

Enter

or 2 option and enter the drive's exact parameters.

Software Problems

only on a diskette or that requires a key disk, try to load

the program at high speed. If you can't load the program

at high speed, set the processor speed to automatic.

EPSON Endeavor WG-8

are installing a drive that cannot

and then F2 at the Hard disk 1

require a key disk but requires a special procedure to

install it on a hard disk, set the speed to low while you

install the program. Then set the speed to high while you

load and run the program. If this does not work, try

installing and loading the program at low speed and then

change to high speed to run it.

program, the ESPEED program, or keyboard commands.

See the User's Guide and

Password

Make sure that you do not forget the password you set. If you

do, you must disable it by setting jumper J13 on the main

system board to position A.

Information Reference List

Engineering Change Notices

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.