Dimplex BLF74 Manual de serviço - Página 9

Procurar online ou descarregar pdf Manual de serviço para Lareira de interior Dimplex BLF74. Dimplex BLF74 16 páginas. Section 10309 manufactured electric fireplaces
Também para Dimplex BLF74: Manual do utilizador (3 páginas)

Imprimir página

Figure 8

Controls Assembly

Figure 9

6 LED

Driver Board

12 LED

Driver Board

Remote

Receiver

2. Slide the controls assembly out toward the front of the

unit.

CAUTION: Ensure that the assembly is removed care-

fully, ensuring that no wires are caught or over strained.

3. Using needle nose pliers, pinch the tabs on either side

of the switch to release and push the switch up and out

of the opening.

NOTE: Note the orientation of the switch prior to re-

moving.

4. Locate the On/Off Switch (Figure 9).

5. Disconnect the wiring connections noting their original

locations.

NOTE: Using a flat head screwdriver gently pry be-

tween the end of the connectors and the switch to release

the wires.

6. Reconnect wires onto the prongs on the switch in their

original configuration.

7. Insert the new switch by pushing switch back through

the hole past the side tabs on the switch, securing it in

the opening.

8. Reassemble in the reverse order as above.

Retaining Screws

On/Off

Switch

Board

Voltage

Selector

Switch

REMOTE SWITCHBOARD

REPLACEMENT

WARNING: Disconnect power before attempting any

maintenance or cleaning to reduce the risk of electric

shock or damage to persons.

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights and heating elements to cool

off to avoid accidental burning of skin.

Tools required: Phillips head screwdriver.

Needle nosed pliers

Wire snips

CAUTION: Follow "Preparation for Service" instructions

before proceeding.

1. Remove the 2 screws, that secure the controls assem-

bly (Figure 8), located at the top of the mirror on the

right side of the unit.

2. Slide the controls assembly out toward the front of the

unit.

CAUTION: Ensure that the assembly is removed care-

fully, ensuring that no wires are caught or over strained.

3. Locate the switchboard (Figure 9).

4. Disconnect the wiring harness from the switchboard.

5. To remove the switchboard off of the plastic mounting

tabs, pinch the plastic mounting tabs with needle nose

pliers. Pull the old board off.

NOTE: If the location of the unit does not allow for the

tabs to be easily manipulated, the top portion of the mount-

ing tabs can be cut off (replacement ones are provided with

the replacement switchboard).

6. Line up the holes on the switchboard and gently press

the new board onto the mounts. Make sure the board

is secure.

7. Reconnect the wire harness onto the back of the

switchboard in its original configuration. .