Dimplex BLF7451-AU Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Lareira de interior Dimplex BLF7451-AU. Dimplex BLF7451-AU 19 páginas. Prism 1.2kw wall mounted electric fire
Também para Dimplex BLF7451-AU: Manual do Proprietário (19 páginas)

Imprimir página
Dimplex BLF7451-AU Manual de instruções
Setup
General Information
Unpack the heater carefully and retain the packaging for possible future use, in the
event of moving or returning the fire to your supplier.
The fire incorporates a flame effect, which can be used with or without heating, so that
the comforting effect may be enjoyed at any time of the year. Using the flame effect
on its own only requires little electricity.
Before connecting the heater check that the supply voltage is the same as that stated
on the heater.
Please note: Used in an environment where background noise is very low, it may be
possible to hear a sound which is related to the operation of the flame effect. This is
normal and should not be a cause for concern.
Electrical Connection
WARNING: THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage marked on the heater
must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating instructions.
Fixed Wiring
In some jurisdictions this appliance is supplied without a plug this is to comply with
the local regulations. In such instances this appliance must be installed by a suitably
qualified installer and the means for disconnection must be incorporated in the fixed
wiring in accordance with the local wiring rules.
Thermal Safety Cut-out
The built-in overheat cut-out, switches off the appliance automatically in the event of
a fault! Should this occur switch off the appliance or disconnect the mains plug from
the socket.
Remove any obstructions which may have caused the overheating. After a short cooling
down phase, the appliance is ready for use again! If the fault should occur again, contact
your local dealer!
WARNING: In order to avoid a hazard due to inadvertent resetting of the thermal cut-
out, this appliance must not be supplied through an external switching device, such
as a timer, or connected to a circuit that is regularly switched on and off by the utility.
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) lamps. These LED lamps are
maintenance-free and should not require replacing during the life of the product.
7