Eckman CS015 Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Motosserra Eckman CS015. Eckman CS015 17 páginas. Telescopic pole chain saw

6. Fill with chain oil before use. Always check oil level before use. A full tank of oil

will last approximately 30 minutes. (See Figure 2)

Pole Saw Information

SAW CHAIN TENSION

WARNING:Unplug chain saw from power source before adjusting saw chain

tension. Severe injury or death could occur from body contact with moving

chain.

WARNING: Cutting edges on chain are sharp. Use protective gloves when

handling chain.

WARNING: When cleaning saw body:-

• do not submerge saw in any liquids

• do not use products that contain ammonia, chlorine, or abrasives

• do not use chlorinated cleaning solvents, carbon tetrachloride, kerosene, or

gasoline

(Note: The saw chain tension is properly set at the factory. A new chain will stretch.

Check new chain tension frequently (after disconnecting the plug from the power

source) during the first 2 hours of operation. Allow chain to cool down. Follow steps

below to check saw chain tension.)

1. Unplug chain saw from power source.

2. Place chain saw on a firm surface to check chain tension.

3. Pull chain with light force 1/8" away from bottom of guide bar and release (See

Figure 3). If chain lightly snaps back into place, tension is correct. A slight sag (1/16"

or less) between chain and bottom of guide bar is acceptable.

Figure 3

Saw Chain Tension Adjustment

1. Loosen guide bar screw before adjusting chain. ( See Figure 4)