MSI 612BF Manual do utilizador - Página 14

Procurar online ou descarregar pdf Manual do utilizador para Placa-mãe MSI 612BF. MSI 612BF 48 páginas. 3d-agp vga / 3d-audio m/b for socket 370
Também para MSI 612BF: Manual (45 páginas)

Imprimir página

Connection for the enclosed parallel port ribbon cable with mounting bracket. Connect the

ribbon cable to this connection and mount the bracket to the case on an open slot. It will

then be available for a parallel printer cable.

NOTE: Serial printers must be connected to the serial port. You can enable the parallel port and choose the

IRQ through BIOS Setup.

6. Serial port COMA and COMB Connector (Two 10-pin blocks): COM1, COM2

These connectors support the provided serial port ribbon cables with mounting bracket.

Connect the ribbon cables to these connectors and mount the bracket to the case on an

open slot. The two serial ports on the mounting bracket will then be used for pointing

devices or other serial devices. See BIOS configuration of "Onboard Serial Port"

Floppy drive Connector (34-pin block): FDD1

This connector supports the provided floppy drive ribbon cable. After connecting the single

plug end to motherboard, connect the two plugs at other end to the floppy drives.

8. Primary IDE Connector (40-pin block): IDE1

This connector supports the provided IDE hard disk ribbon cable. After connecting the

single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If

you install two hard disks, you must configure the second drive to Slave mode by setting its

jumpers accordingly. Please refer to the documentation of your hard disk for the jumper

settings.

Secondary IDE Connector (40-pin block): IDE2