Philips 7000 series Manual do utilizador - Página 6

Imprimir página

Philips 7000 series Manual do utilizador

3 Get started

Charge the battery

Note

 Before you use your headphones, charge it for

two hours for optimum battery capacity and

lifetime.

 Use only the original USB charging cable to

avoid any damage.

 Finish your call before charging. Connecting the

headphones to charge will power them oﬀ.

Connect the supplied charging

cable to:

• Magnetic charging slot on the

headphones and;

• The charger/USB port of a computer.

LED turns blue during charging and

turns oﬀ when the headphones is

fully charged.

Tip

 Normally, a full charge takes 2 hours.

Pair the headphones with

your mobile phone

Before you use the headphones with your

mobile phone for the �rst time,

pair it with a mobile phone. A successful

pairing establishes a unique encrypted

link between the headphones and mobile

phone. The headphones store the last 4

devices in the memory. If you try to pair

more than 4 devices, the earliest paired

device is replaced by the new one.

Make sure that the headphones are

fully charged and turned oﬀ.

Press and hold

the blue and white LED �ash quickly.

The headphones remain in

pairing mode for 5 minutes.

Make sure that the mobile phone is

turned on and its Bluetooth feature is

activated.

Pair the headphones with the mobile

phone. For detailed information,

refer to the user manual of your

mobile phone.

The following example shows you how to

pair the headphones with your mobile

phone.

Activate the Bluetooth feature of

your mobile phone, select

Philips TAA7607.

Enter the headphones' password

"0000" (four zeros) if prompted. For

those devices featuring Bluetooth

3.0 or higher, there is no need to

enter a password.

for 4 seconds until

Philips TAA7607