Toshiba TDP-D2 - XGA DLP Projector Manual do Proprietário - Página 9

Procurar online ou descarregar pdf Manual do Proprietário para Projetor Toshiba TDP-D2 - XGA DLP Projector. Toshiba TDP-D2 - XGA DLP Projector 20 páginas. Toshiba dlp data projector tdp-d1 tdp-d2 owner's manual

Imprimir página

Preparing and using the remote control

I Loading dry-cell batteries
into the remote control
q Remove the battery cover.
w Insert the dry-cell batteries.
Be sure to align the plus and minus
ends of the batteries properly.
Two batteries (R03, SIZE AAA) are
used.
e Replace the battery cover.
Batteries
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the batteries
with new ones.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If
this happens, point the remote control at the main unit again, and repeat the operation.
I Operating the remote control
Point the remote control toward the
projector's infrared remote sensor,
and press a button on the remote
control.
• Operating the projector from the front
Approx. 15°
• Operating the projector from the rear
EO
S-VID
VIDE
O
O IN
AUDI
CON
TROL
USB
Approx. 15°
O OUT
AUDI
16

Placement

Placement Styles
As shown in the figures below, this device can be placed in 4 different styles.
The factory setting is "floor-mounted front projection." Set the placement style in the
default setting menu
p.28
, in accordance with your needs.
Floor-mounted front projection
Ceiling-mounted front projection
CAUTION
• Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when
placing the unit.
• If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so.
Mounting the projector on a ceiling requires special ceiling brackets (sold separately)
and specialized knowledge. Improper mounting could cause the projector to fall,
resulting in an accident.
Projection Distance and Screen Size
Use the figures, table, and formula below to determine the screen size and projection distance.
(Screen sizes are approximate values for full-size picture and no keystone adjustment)
As seen from above
Screen
°
90
As seen from the side
Lens center
°
b
90
a
"a" is the distance (m) between the lens and the screen, and corresponds to a range of 1.4 m to 6 m.
"b" is the distance (cm) between the lens center and the bottom of the projection image.
Floor-mounted rear projection
Ceiling-mounted rear projection
a (min. length) = projection size (inches) x 0.0333
a (max. length) = projection size (inches) x 0.0406
b = projection size (cm) x 0.096
projection distance a (m)
screen
min length
max length
size (cm)
(zooming max)
(zooming min)
37 (94)
—
1.50
45 (114)
1.50
1.83
60 (152)
2.00
2.44
80 (203)
2.66
3.25
100 (254)
3.33
4.06
148 (376)
4.93
6.00
180 (457)
6.00
—
17
b
(cm)
9.0
11.0
14.6
19.5
24.4
36.1
43.9