Toshiba TDP-MT500 Manual do Proprietário - Página 32
Procurar online ou descarregar pdf Manual do Proprietário para Projetor Toshiba TDP-MT500. Toshiba TDP-MT500 40 páginas. Home projector
Também para Toshiba TDP-MT500: Manual do Proprietário (42 páginas)
Imprimir página
USING THE MENUS
Adjusting picture images sent from computers
This projector automatically sets an appropriate signal processing format according to the image signal sent from
computers. However, depending on the type of the computer, the image signals may not be projected properly. If
this happens.
1 Bring up the INSTALLATION menu.
2 Select "RGB & COMPONENT" by pressing the {, } buttons.
3 Press ENTER button.
•
The RGB & COMPONENT menu appears.
4 Select "AUTO" by pressing the {, } buttons.
5 Press the ENTER button.
•
The automatic setting is made so that an appropriate setting may be obtained for the input signal.
To cancel the menus:
6 Press the MENU button.
If the computer images can not be projected properly with the above operation, adjust the images using
the menus. These settings can be stored in the memory of the projector.
How to adjust computer images using menus:
If the following phenomena are observed, adjust as follows:
Projected images are shifted to the left or right: .......................... Adjust "H.POS" in the RGB & COMPONENT
Projected images are shifted up or down: ................................... Adjust "V.POS" in the RGB & COMPONENT
Projected images blink.
Projected images are blurred: ..................................................... Adjust "PHASE" in the RGB & COMPONENT
A wide streak pattern appears on the projected images: ............ Adjust "FREQUENCY" in the RGB & COMPO-
•
Usually, do not change the settings in the RGB & COMPONENT menu.
A simple method of adjusting the position of projected images
Adjusting horizontal position:
1 Align the left edge of the projected image with the left side of the screen by adjusting "H.POS". Then, align
the right edge with the right side of the screen by adjusting "FREQUENCY".
2 Repeat the above adjustments to align the horizontal position.
Adjusting vertical position:
3 Align the upper edge of the projected image with the upper side of the screen by adjusting "V.POS".
32
menu. Every time the $ button is pressed, the
projected image is shifted to the left. Every time
the % button is pressed, the projected image is
shifted to the right.
menu. Every time the $ button is pressed, the
projected image is shifted downward. Every time
the % button is pressed, the projected image is
shifted upward.
menu.
NENT menu.