3Com 3crwe875075a Manual de configuração - Página 8
Procurar online ou descarregar pdf Manual de configuração para Ponto de acesso sem fios 3Com 3crwe875075a. 3Com 3crwe875075a 10 páginas. Wds bridging and antenna installation
Também para 3Com 3crwe875075a: Manual de conversão (10 páginas), Manual de início rápido (8 páginas)
Imprimir página
4
Install the Root-Bridge.
The Root-Bridge is installed in the main building that has the physical LAN link.
a
Connect the Root-Bridge to the wired LAN.
b
Connect the external 3CWE491 antenna to the SMA connector that is closest to the
LEDs on the access point using the 3CWE580 cable.
c
Mount the antenna in an area that has a direct "line of sight" from the Root-Bridge to
the Child Bridge.
5
Install the Child Bridge.
The Child Bridge is installed in the remote building where you want to gain wireless
network access.
a
Connect the external 3CWE596 antenna to the access point using the 3CWE580 cable.
b
Mount the antenna and aim it toward the Root-Bridge antenna.
Note: For best performance, make sure the antennas are mounted at
approximately the same height.
c
Plug in the access point and verify the WDS link is active.
To verify the WDS link, access the Configuration Management System and select
Advanced Setup, Status, AP Status.
d
Configure the 802.11g radio for local access point service.
The Child Bridge now has a secure wireless connection to the network.
e
Connect to the network via the access point to verify the connection.
8