Croydex Flexi-Fix Riser Rail AM182041 Instruções de fixação e conservação - Página 3

Procurar online ou descarregar pdf Instruções de fixação e conservação para Luminárias de casa de banho Croydex Flexi-Fix Riser Rail AM182041. Croydex Flexi-Fix Riser Rail AM182041 4 páginas.

Imprimir página
C
WHEN USING ADHESIVE FIXING METHOD
Before starting
ensure all surfaces
are clean and free
from dirt and soap
residue, particularly if
adhereing to tiled
walls.
Place assembled wall plate in desired
location and press firmly.
Undo locking nut and remove wall plate
leaving the alignment guide stuck to wall
Cut the end of the sachet and apply a
generous amount of adhesive to the
back of the wall plate as shown. (Each
sachet has sufficient adhesive for two
wall plates).
3
Place the square nut
into the recess in the
back of the wall
bracket.
Assemble wall plate, alignment guide
and locking nut as shown.
Partially insert the
grub screw into the
threaded hole in the
square nut.
(
TIP!
To ensure the
Riser Rail is vertical,
mark the wall
using one wall
plate and
using a spirit level,
mark the second
plate whilst being
careful not to
exceed the
recommended
centre distances.
Sufficient adhesive
must be applied to
give a uniform
thickness of
approximately
1.5mm when the
wall plate is
positioned against
the wall.
Once the Flexi-Fix
wall plates are
secured to the wall,
place the Riser Rail
brackets over each
of the Flexi-Fix wall
plates and secure by
tightening the grub
screw with the hex
key provided.
DO NOT
OVERTIGHTEN.
Please refer to Important Adhesive Information at
the front of this leaflet before proceeding
Remove backing from adhesive
pad on alignment guide.
i
AM182441 / AM182541 /
AM182641
Max Distance = 720mm
Carefully place the wall plate over the
alignement quide and allow the rotation
of the locking nut to secure the wall plate
in position. DO NOT PRESS IN POSITION!!
Leave the adhesive to set for 24 Hours
Step 3
Image shown for reference only - grub screw
previously fitted into wall bracket.
)
LEAVE
24
HOURS
SWR 060 R02