Dimplex CKHA20D31W Manual

Procurar online ou descarregar pdf Manual para Aquecedor Dimplex CKHA20D31W. Dimplex CKHA20D31W 3 páginas. Ckha/rkha series kickspace heater
Também para Dimplex CKHA20D31W: Manual de instruções (3 páginas)

Imprimir página

Kickspace Heater

CKHA/RKHA Series

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should

always be followed to reduce the risk of fire, electric shock,

and injury to persons, including the following:

1. Read all instructions before using the heater.

2. The heater is hot when in use. To avoid burns, do not let

bare skin touch hot surfaces. The trim around the heater

outlet becomes hot during heater operation. Keep com-

bustible materials, such as furniture, pillows, bedding,

papers, clothes, and curtains at least 3 ft (0.9 m) from the

front of the unit and keep them away from the sides and

rear.

3. Extreme caution is necessary when any heater is used

by or near children or invalids and whenever the unit is

left operating and unattended.

4. Do not operate any heater after it malfunctions. Discon-

nect power at the service panel and have the heater in-

spected by a reputable electrician before reusing.

5. Do not use outdoors.

6. To disconnect the unit, turn the controls off, and then

switch off at main power supply panel.

7. Do not insert or allow foreign objects to enter any venti-

lation or exhaust opening as this may cause an electric

shock or fire, or damage to the heater.

8. To prevent a possible fire, do not block air intake or ex-

haust in any manner.

9. All electrical heaters have hot and arcing or sparking

parts inside. Do not use in areas where gasoline, paint,

or flammable liquids are used or stored.

10. Do not modify this heater. Use it only as described in

this manual. Any other use not recommended by the

manufacturer may cause fire, electric shock or injury to

persons.

SAVE THESE INSTRUCTIONS

Installation Instructions

WARNING: To reduce the risk of fire, do not store or use

gasoline or other flammable vapors or liquids in the vicinity of

the heater.

CAUTION: High temperature, risk of fire, keep electrical

cords, drapery, furnishings, and other combustibles at

least 3 feet (0.9 m) from the front of the heater.

! NOTE: It is extremely important to read all information

labels. Care must be taken to ensure that the heater is

rated the same voltage as the electrical supply wires.

Failure to do so could result in unsafe heater operation as

well as damage to the unit. If replacing an existing heater,

check the labels of the old heater to ensure the voltage of

the new heater is compatible.

! NOTE: Care must be taken to prevent undue strain on all

wiring or heating element assembly, when removing and

re-assembling heating element assembly.

CAUTION: For field rewiring to 120V all leads must be

secured under wire clamps.

! NOTE: Air and grille temperatures conform to CSA & UL

regulations but may discolour certain materials, particu-

larly those materials incorporating clear vinyl. Materials

should be checked prior to installation to determine if

discolouration or distortion would occur in the vicinity of

60° C (140° F)

Kickspace Installation

! NOTE: Unit should be installed so that it is not directly

under sink or other frequently used work area as air tem-

perature may be uncomfortably warm. Also, if carpeting is on

floor, mount unit so bottom of grille is level or above the top

of the carpet pile.

1. Measure area of intended use. If there is not sufficient

room for the grille frame, the frame may be removed by

removing grille frame from heater (screw "A"), remove

frame and re-insert grille.

2. Cut 22 3/8" x 3 5/8" opening (Figure 2). Keep clearance

area free of obstructions.

3. Bring in service cable to left or rear of 10" minimum area

FIGURE 1

Heater Cover

Top Label

Junction Box Cover

Screw 'C'

Screw 'A'

FIGURE 2

10" MIN.

SERVICE

CABLE

22"

KNOCKOUTS

Heater

Element

Screw'B'

Grille

Trim Frame

22 3/8"

3 5/8"

3 1/2"

9 1/2"

7200960100R08