CRU Dataport RTX800-XJ Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Invólucro CRU Dataport RTX800-XJ. CRU Dataport RTX800-XJ 2 páginas.

2. Installation Steps

2.1 Installing a Host Bus Adapter (optional)

The following general steps will work for most cards.

Instructions for individual cards may vary, so consult your card's user manual.

a. Power down the computer system.

b. Insert the adapter card into a compatible slot. Do not force it, but it will take firm

pressure to fully seat the interface. It may help to gently rock the card back and

forth as you apply pressure.

c. Once the card is fully seated in the slot, secure it in place with a screw.

d. Turn the computer back on.

NOTE: Drivers for the R680 that comes with the RTX800-XJ

Bundle can be found at ATTO's website: www.attotech.com.

Drivers for the REDPort SAS 6G card are also found at the

ATTO website. Use the drivers for the ATTO ExpressSAS

H644. RedPort SAS 6G was designed in partnership with

ATTO, and is based on ATTO's H644 hardware.

2.2 Hard Drive Installation

a. Pull on the ejection handle and open the door.

b. Slide in your SAS or SATA hard drive, connector-end first. The drive's label should

be facing up.

c. Shut the door.

With RTX800-XJ, you can lock the bay for additional security, but make sure to unlock

it before pulling on the ejection handle again.

2.3 Connecting and powering RTX800-XJ

RTX800-XJ has two multi-lane SAS/SATA (SFF-8088) connections on the rear of

the unit. These connections can go to any host bus adapter so long as the proper

converter cable is attached. (RTX800-XJ Bundle includes

the appropriate cables.)

Plug in the SAS/SATA cable from your computer to the

RTX800-XJ. Plug in the power cord. With hard drives in

the unit, turn it on. RTX800-XJ is ready to use!

If the hard drives are already formatted, RTX can be used right away. If the hard

drives are brand new, or the formats are not compatible with your computer, the

drives will need to be formatted before being used.

NOTE: If any of the drives are inaccessible after powering on

the unit, try the following steps:

1. Turn off the power.

2. Remove the drive(s) in question.

3. Reinsert the drive(s).

RTX220 QR - Manual

Multi-lane SAS/

SATA connection

(SFF-8088)