CRU Dataport Dataport 25 SL Manual de instalação

Procurar online ou descarregar pdf Manual de instalação para Armazenamento CRU Dataport Dataport 25 SL. CRU Dataport Dataport 25 SL 2 páginas. Hard drive carrier
Também para CRU Dataport Dataport 25 SL: Manual de instalação (2 páginas)

Imprimir página

CRU Dataport Dataport 25 SL Manual de instalação

DataPort 25 Install Guide

The DataPort 25 is a low profile DataPort designed to fit two 2.5" hard drives into

a 3.5" drive bay. The DataPort 25 has a universal frame that supports both IDE and

SATA drive carriers. The IDE or SATA carriers support one or two 2.5" hard drives.

Installing the Frame Into Your Computer

1. Locate an available 3.5" drive bay and remove the front bezel.

2. To mount the frame assembly in the drive bay:

a. Check the drive bay to see if mounting rails are required

(they should be provided by your computer system

manufacturer.) If required, install one on each side of the

frame. Then slide the frame in the computer and check

that it is secure.

b. If mounting rails are not required, attach the frame directly

to the PC case using the screws provided. Either the side

or bottom mount holes on the frame may be used.

The Activity LED is normally on during Serial ATA access only.

3. Locate and connect an available 4-pin power connector (the type

used for floppy drives) to the back of the DataPort 25 frame.

4. Connect the data cables to the rear of the frame. See Opera-

tions section for details on proper cabling.

Your frame assembly is complete.

IDE Connector

SATA

SATA Top Drive

Bottom Drive

Connector

Power Connector

Connector

Rugged, Reliable, Mobile, Secure

Installing a Hard Drive in Your DataPort 25 Carrier

1. Remove the two screws that hold the cover and slide the

cover off.

Note: Do NOT use screws longer than those supplied as

the circuit board will be damaged.

2. Connect the hard drive(s) to their respective connector(s) on

the circuit board. Use the provided screws to secure the hard

drive.

3. Slide the cover back on to the carrier and secure it with the

cover screws.

4. Once the carrier has been seated in the frame the key lock

must be turned 90 degrees (horizontal) to engage the lock and

enable the power.

1-800-260-9800

Installing Hard Drive