CRU Dataport DataPort 250 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Hardware informático CRU Dataport DataPort 250. CRU Dataport DataPort 250 12 páginas. Usb 2.0 enclosure

Imprimir página

NSTALLING THE

ARD

ISK

1. Leverage the side of the enclosure open with a small screwdriver.

2. Slide the hard drive onto the connector.

3. Close the enclosure by connecting one side then clipping in the other.

4. Connect the provided USB cable between your computer's USB port and

the DP250 enclosure.

5. There are three ways to power your DP250 enclosure and hard drive:

USB bus powered, PS/2 port, and external power supply (AC power

adapter):

Bus powered: If your computer's USB port features standard USB

port power (DC 5V / 0.5A), your USB port will supply adequate

power for most applications. However, certain models of hard drives

may require additional power. Also, if the bus power is shared by more

than one USB device, there may not be sufficient power for the DP250

and hard drive. Where USB bus power is not sufficient, the PS/2 port

or external power supply should be used.

PS/2 port: The PS/2 port on your computer can be used to supply

power to your DP250. Plug the provided PS/2 power cable into an

available PS/2 port on your computer. Plug the power input end of the

PS/2 cable into the power input on the back of the DP250 enclosure.

(The PS/2 cable also provides a connector for your keyboard. If

desired, your keyboard can be unplugged from your computer to free

up a PS/2 port. Your keyboard can then be plugged into the PS/2

connector on the power cable). The PS/2 power cord will power the

DP250 enclosure and drive provided your computer's PS/2 port

supplies sufficient power.

An external power supply is also provided in case your computer

does not supply adequate power through the USB bus or PS/2 port.

To use the external power supply, plug the power cord into the back of

the enclosure (which requires DC 5V / 2.0A provided by the power

supply) and into an external power source. Power source is a standard

AC 100-240V 47-63 Hz outlet.

WWW.CRU-DATAPORT .COM • (800) 260-9800

(DP250)

RIVE

Power

Input

Diagram 1 Rear panel 250 USB enclosure

WWW.CRU-DATAPORT .COM • (800) 260-9800

USB input

Diagram 2