Crua Outdoors X-Tent Manual de instruções - Página 2

Procurar online ou descarregar pdf Manual de instruções para Tenda Crua Outdoors X-Tent. Crua Outdoors X-Tent 2 páginas.

Flex Poles into

an arch.

Clip plastic hooks

to poles.

Insert

Unclip

Extension Poles

Reclip & Adjust

Take down

instructions

• After sliding the poles through the sleeves, ﬂex the poles into an arch and insert the pin attached to the

tent into the pole.

• Find the plastic hooks on the tent and clip them to the poles. NOTE: some of the clips have adjustments

on the webbing. This is to help pull the tent taught. The tent should be taught, but not tight. If the

webbing is pulled too tight, then it may aﬀect the operation of the door.

• Properly stake down the 4 corners of the tent. The ﬂoor for the tent should be taught.

• Ensure that the toggles on the bug mesh are connected and you are ready to use your tent in low mode.

• To increase the tent to standing height, unclip the toggles on the bug mesh. Unclip all the plastic clips

from the poles. Starting at one corner, take the pin out of the pole, slide the extension section into the

pole, then replace the pin into the extension section. Repeat this process for the remaining three corners.

• Re-clip and re-adjust the plastic clips to the poles.

• When adding the ﬂysheet, unclip the mini carabiners and guylines that are attached to the tent.

• Put the ﬂysheet over the top of the tent-making sure it is centered.

• If the tent is in the down position, the ﬂysheet will come down to the ground and stake in to the ground

directly. If the tent is in the up position, there will be a gap between the ﬂysheet and the ground. Use

the provided guy ropes to stake the corners down to the ground.

• Re-attach the mini carabiners and guylines to the ﬂysheet and adjust the guylines accordingly.

NOTE: The tent should not be used in the up position when there is a lot of wind or inclement weather. In the low position,

it will weather the storm eﬀectively. Using the porch poles: place the porch poles in the eyelets on the corner of the ﬂysheet.

(there is an extension piece to the ﬂyheet if you want more porch space). Guy down the porch once the poles are installed.

• Remove stakes from guy-lines and store in stake bag.

• Remove ﬂysheet hooks from poles.

• Remove porch pole above the door on the tent, then slide out of ﬂysheet.

• Remove the tent poles by carefully pushing them through the sleeves away from the end from

which you are standing.

• Disassemble all the poles and place them in the pole bag.

• Fold both sides to meet in the middle and then fold one more time together. Roll again to ﬁt in

the bag.

• Always roll towards the door of the tent. This will help the air trapped in the tent or the air beams.

• Fold the ﬂysheet in half and then in half again and roll up.