Cruiser Sup Voyager AIR 11’6” Manual de operação - Página 4

Procurar online ou descarregar pdf Manual de operação para Acessórios Cruiser Sup Voyager AIR 11’6”. Cruiser Sup Voyager AIR 11’6” 8 páginas.

Attach the air hose to the pressure gauge. Then attach the

pressure gauge (with hose now attached to it) to the pump itself.

Ensure that there is no water or debris in the valve and then take

the other side of the air hose and attach to the valve on the board

by twisting in a clockwise direction until snug.

by twisting the cap in a clockwise motion.

Tips:

•

A few days after you inflate your SUP you may need to add more air due to temperature changes. Use

your hand pump to inflate back to 15-17 psi.

•

If you are using your board in a very hot or humid environment, inflate to slightly less pressure.

•

Never leave your board in direct sunlight or in an area without ventilation.

•

Rinse your SUP after every single use and ensure that the valve is free of any sand, dirt, or other debris.

Inflating Your Stand Up Paddle Board

The valve for inflating your SUP is located near the tail of the board.

Twist counterclockwise to unlatch outside cover. Ensure that the pin

located at the center of the valve is in the "up" position when inflating.

To reach the "up" position twist the pin counterclockwise until it pops

out toward you. When deflating, push the pin in and turn clockwise

until it is locked in the "down" position. When the pin is in the "down"

position the board will deflate without having to hold the pin in.

Once both ends of the hose are secure from the board to the pres-

sure gauge attached to the pump, begin pumping air into the board.

If you feel or hear air leaking from either end of the hose ensure that

you have connected the hose properly. Continue to pump air until

you have reached between 15-17 psi. The maximum recommend

psi is marked on your board at 17 psi for a reminder. Once you have

reached the desired pressure, twist the air hose off by doing a quick

counterclockwise twist. Now twist the valve cap back on for protection