Aeon Labs Aeotec Heavy Duty Smart Switch Gen5 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Interruptor Aeon Labs Aeotec Heavy Duty Smart Switch Gen5. Aeon Labs Aeotec Heavy Duty Smart Switch Gen5 8 páginas.

11/22/2017
5. Power on your Heavy Duty Smart Switch. At this stage you need to add it to your Z-Wave network. If you're using an
Aeotec Z-Stick or Minimote, please refer the "Z-Wave Network Instructions" section of this user guide. If you're using an
alternative gateway, please refer to the respective section of its user manual using your Heavy Duty Smart Switch's
Action Button to put it into inclusion mode.
6. The product can be mounted on a wall or surface. To do so, drill a ø2.5mm hole that corresponds to the up upper part
of your switch. Drill a second hole 138mm directly below then Affix the screws. Your installation is now complete.
Note:
1. Your switch should be installed in a ventilated area with good heat dissipation.
2. Your switch should access to the protective earth (green/yellow) line.
3. Your switch should have front-end access to a short-circuit protection.
4. Only professionals should install, repair, or open your switch's casing
Alternative Wiring Schematics
You may find other wiring schematics for using 120VAC (1 phase), 240VAC (2 phase), or EU based applications here:
Wiring Schematics
(https://aeotec.freshdesk.com/solution/articles/6000108707-heavy-duty-smart-switch-gen5-wiring-
diagrams-)
Z-Wave network instructions.
Your Heavy Duty Smart Switch must be paired with a Z-Wave network before it can receive wireless commands or report
the energy consumption of the attached electronics.
Note: The LED on your Heavy Duty Smart Switch will blink if it is not currently paired with a Z-Wave network.
Tip: Turn off any devices connected to your Heavy Duty Smart Switch before adding or removing it to/from a Z-Wave
network. This will help to prevent load damage.
Adding your Heavy Duty Smart Switch Gen5 to a Z-Wave network.
Pairing your Heavy Duty Smart Switch Gen5 into your existing Z-Wave network.
1. Place your gateway or controller into Z-Wave pair or inclusion mode. (Please refer to your controller/gateway manual
on how to do this)
2. Press the Action Button on your Switch.
3. If your switch has been successfully linked to your network, its LED will no longer blink. If linking was unsuccessful,
the LED will continue to blink.
If you're using a Z-Stick.
https://aeotec.freshdesk.com/support/solutions/articles/6000161813-heavy-duty-smart-switch-gen5-user-guide-
Heavy Duty Smart Switch Gen5 user guide. : Aeotec by Aeon Labs
5/8