Aeon Labs ZW175 Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Interruptor Aeon Labs ZW175. Aeon Labs ZW175 9 páginas.

Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or

may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage

resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only

for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a

fire or near open heat sources.

Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use

in the region mentioned in the Quickstart section.

Z-Wave ensures a reliable communication by reconfirming every

message (two-way communication) and every mains powered

node can act as a repeater for other nodes (meshed network) in

case the receiver is not in direct wireless range of the transmitter.

This device and every other certified Z-Wave device can be used

together with any other certified Z-Wave device regardless of

brand and origin as long as both are suited for the same

frequency range.

If a device supports secure communication it will communicate

with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will

automatically turn into a lower level of security to maintain backward compatibility.

For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.

The Aeotec Smart Switch 7 is an elegant appearance, small size, easy to use, Smart Plug. This supports power

metering function, with high measurement accuracy, and more accurate knowledge of the power consumption of

the load, over-current, over-load and over-heat protection, which is more secure and reliable, scene

personalization and is more intelligent, Night Light Mode to reduce light pollution, S2 Security, which is safer

and more reliable and SmartStart, making inclusion more convenient.

Please read the user manual before installing the product.

In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to

reset the device into factory default. You can do this by performing an Exclusion operation as described below in

the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the

primary controller of the previous network to make sure the very device is excluded properly from this network.

Reset to factory default

This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only

be used when the primary controller is inoperable.

If not, plug it into a wall socket and power on. To complete the reset process manually, press and hold the Action

Button for at least 15s and then release. The LED indicator will become breathing blue light, which indicates the

reset operation is successful. Otherwise, please try again.