Aeon Labs Aeotec Water Sensor 6 Manual - Página 5
Procurar online ou descarregar pdf Manual para Acessórios Aeon Labs Aeotec Water Sensor 6. Aeon Labs Aeotec Water Sensor 6 12 páginas. Z-wave water sensor
Imprimir página1. Power on Water Sensor. The Water Sensor's LED will blink slowly when you short press the
Action Button.
2. Let the primary controller into inclusion mode (If you don't know how to do this, refer to its
manual).
3. Press the Action Button.
4. If the inclusion is success, Water Sensor's LED will be kept turning on for 8 seconds when you
short press the Action Button. If the LED is still in slow blink, in which you need to repeat the
process from step 2.
3.
Remove Water Sensor from Z-wave network:
1. Power on Water Sensor. The Water Sensor's LED will be kept turning on for 8 seconds when
you short press the Action Button.
2. Let the primary controller into exclusion mode (If you don't know how to do this, refer to its
manual).
3. Press the Action Button.
4. If the exclusion is success, Water Sensor's LED will blink slowly when you short press the Action
Button. If Water Sensor's LED still keeps on status, in which you need to repeat the process from
step 2.
Quick press 2
1.
Send Security Node Info frame.
times within 1
2.
Add Water Sensor into z-wave network(
second
1. Power on Water Sensor. The Water Sensor's LED will blink slowly when you short press the
Action Button.
2. Let the primary controller into inclusion mode (If you don't know how to do this, refer to its
manual).
3. Press the Action Button.
4. If the inclusion is success, Water Sensor's LED will be kept turning on for 8 seconds when you
short press the Action Button. If the LED is still in slow blink, in which you need to repeat the
process from step 2.
3.
Remove Water Sensor from Z-wave network:
1. Power on Water Sensor. The Water Sensor's LED will be kept turning on for 8 seconds when
you short press the Action Button.
2. Let the primary controller into exclusion mode (If you don't know how to do this, refer to its
manual).
3. Press the Action Button.
4. If the exclusion is success, Water Sensor's LED will blink slowly when you short press the Action
Button. If Water Sensor's LED still keeps on status, in which you need to repeat the process from
step 2.
Press and hold
Enable/disable wake up for 10 minutes.
for 3 seconds
(When it is enabled, the orange Led will fast blink)
Press and hold
Reset Water Sensor to factory default:
for 20 seconds
1. Press and hold the Action Button for 20 seconds.
2. If holding time more than one second, the LED will blink faster and faster. If holding time more than
20 seconds, the LED will be on for 2 seconds, which indicates reset is success, otherwise please
repeat step 2.
Note:
Security inclusion
Page 5
):