DimSport YOUTUNE Manual de instalação e utilização - Página 3
Procurar online ou descarregar pdf Manual de instalação e utilização para Acessórios para motociclos DimSport YOUTUNE. DimSport YOUTUNE 10 páginas. Controller for rapid bike evo and rapid bike racing modules
Imprimir página1. Fasten the device, using the provided Velcro, in a position easy to
look at and reach (see pictures).
2. Route the wiring harness up to the
Rapid Bike module and fasten it to
the OEM harness using cable ties.
3. Connect the three connectors of the
Youtune harness to the Rapid Bike
harness.
Turn ignition on.
4. The device must light up all the LEDs as well as the display; then it
should set to RPM position showing 0 rpm.
The device is ready.
The device flashes continuously in case a communication problem is detected:
Ten LEDs on a curved
line for analog
representation of the
measured value
Button MODE selects the
feature and saves new
settings (memorizing new
default feature)
Six LEDs indicating the selected feature:
TC => Traction Control
EB => Engine Braking
QS => Electronic Quick Shifter
AFR => Air Fuel Ratio
LC => Launch Control
RPM => Revolutions per Minute
Issued by: PM
Installation
1. Update the Rapid Bike module's firmware as mentioned previously.
2. Youtune harness may have been damaged during installation. Check it and
repair.
approved by DG
WARNING
Use
Button (-)
decreases
the value
displayed
Rev.01
Button (+) increases the
value displayed. Pressed
together with button (-)
allows modifying the
brightness
Alphanumeric display
shows the value of the
selected feature
date 03/09/18
pag. 3/10