Pioneer AVG-VDP1 Manual de instalação - Página 5

Procurar online ou descarregar pdf Manual de instalação para Recetor para automóvel Pioneer AVG-VDP1. Pioneer AVG-VDP1 30 páginas. Vehicle dynamics processor
Também para Pioneer AVG-VDP1: Manual (39 páginas)

Imprimir página

Note:

• This unit is for vehicles with a 12-volt battery and

negative grounding. Before installing it in a recre-

ational vehicle, truck, or bus, check the battery

voltage.

• To avoid shorts in the electrical system, be sure to

disconnect the ≠ battery cable before beginning

installation.

• Refer to the owner's manual for details on

connecting the power amp and other units, then

make connections correctly.

• Secure the wiring with cable clamps or adhesive

tape. To protect the wiring, wrap adhesive tape

around them where they lie against metal parts.

• Route and secure all wiring so it cannot touch any

moving parts, such as the gear shift, handbrake

and seat rails. Do not route wiring in places that

get hot, such as near the heater outlet. If the insu-

lation of the wiring melts or gets torn, there is a

danger of the wiring short-circuiting to the vehicle

body.

• Don't pass the yellow lead through a hole into the

engine compartment to connect to the battery.

This will damage the lead insulation and cause a

very dangerous short.

• Do not cut the GPS antenna cable to shorten it or

use an extension to make it longer. Altering the

antenna cable could result in a short circuit or

malfunction.

• Do not shorten any leads. If you do, the protection

circuit may fail to work when it should.

• Never feed power to other equipment by cutting

the insulation of the power supply lead of the unit

and tapping into the lead. The current capacity of

the lead will be exceeded, causing overheating.

• When replacing the fuse, be sure to only use a

fuse of the rating prescribed on the fuse holder.

• If this unit is installed in a vehicle that does not

have an ACC (accessory) position on the ignition

switch, the red lead of the unit should be connect-

ed to a terminal coupled with ignition switch

ON/OFF operations. If this is not done, the vehi-

cle battery may be drained when you are away

from the vehicle for several hours.

ACC position

• Cords for this product and those for other prod-

ucts may be different colors even if they have

the same function. When connecting this product

to another product, refer to the supplied manuals

of both products and connect cords that have the

same function.

No ACC position