Pioneer AVIC-6100NEX Manual de instalação - Página 28
Procurar online ou descarregar pdf Manual de instalação para Recetor para automóvel Pioneer AVIC-6100NEX. Pioneer AVIC-6100NEX 34 páginas. System firmware update instructions
Também para Pioneer AVIC-6100NEX: Manual de atualização do firmware (7 páginas), Manual de operação (10 páginas)
Imprimir página
Section
03
Installation
! The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
! The semiconductor laser will be damaged
if it overheats, so don't install this product
anywhere hot — for instance, near a heater
outlet.
Parts supplied
Parts marked (*) are supplied with AVIC-6100-
NEX and AVIC-5100NEX.
This product
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
28
En
Do not cover this area.
Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Screw*
(2 mm × 4 mm)
(1 pc.)
Installation using the screw
holes on the side of this product
% Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three locations
on each side.
Use either the truss head screws (5 mm ×
8 mm) or flush surface screws (5 mm ×
9 mm), depending on the shape of the brack-
et's screw holes.
If the pawl interferes with installation,
you may bend it down out of the way.
3
1 Factory radio-mounting bracket
2 Dashboard or console
3 Truss head screw or flush surface screw
Be sure to use the screws supplied with
this product.
1
2