Pioneer AVIC-F70BT Manual de instalação - Página 6

Procurar online ou descarregar pdf Manual de instalação para Recetor para automóvel Pioneer AVIC-F70BT. Pioneer AVIC-F70BT 32 páginas. In-dash navigation av receivers and dvd receivers

Imprimir página

Section

Connection

To prevent damage

WARNING

! Use speakers over 50 W (output value)

and between 4 W to 8 W (impedance value).

Do not use 1 W to 3 W speakers for this

unit.

! The black cable is earth. When installing

this unit or power amp (sold separately),

make sure to connect the earth wire first.

Ensure that the earth wire is properly con-

nected to metal parts of the car's body.

The earth wire of the power amp and the

one of this unit or any other device must

be connected to the car separately with

different screws. If the screw for the earth

wire loosens or falls out, it could result in

fire generation of smoke or malfunction.

Earth wire

Other devices

(Another electronic

device in the car)

Not supplied for this unit.

! When replacing the fuse, be sure to only

use a fuse of the rating prescribed on this

product.

! When disconnecting a connector, pull the

connector itself. Do not pull the lead, as

you may pull it out of the connector.

! This product cannot be installed in a vehi-

cle without ACC (accessory) position on

the ignition switch.

ACC position

Engb

Power amp

Metal parts of car's body

No ACC position

! To avoid short-circuiting, cover the discon-

nected lead with insulating tape. It is espe-

cially important to insulate all unused

speaker leads, which if left uncovered may

cause a short circuit.

! Attach the connectors of the same colour

to the corresponding coloured port, i.e.,

blue connector to the blue port, black to

black, etc.

! Refer to the owner's manual for details on

connecting the power amp and other units,

then make connections accordingly.

! Since a unique BPTL circuit is employed,

do not directly earth the * side of the

speaker lead or connect the * side of an-

other side of the speaker lead together. Be

sure to connect the * side of the speaker

lead to the * side of the speaker lead on

this product.

Notice for the blue/white lead

! When the ignition switch is turned on (ACC

ON), a control signal is output through the

blue/white lead. Connect to an external

power amp's system remote control term-

inal, the auto-aerial relay control terminal,

or the aerial booster power control terminal

(max. 300 mA 12 V DC). The control signal

is output through the blue/white lead, even

if the audio source is switched off.

! Be sure not to use this lead as the power

supply lead for the external power amps.

Such connection could cause excessive

current drain and malfunction.

! Be sure not to use this lead as the power

supply lead for the auto-aerial or aerial

booster. Such connection could cause ex-

cessive current drain and malfunction.