Pioneer CDX-P670 Manual de serviço - Página 32

Procurar online ou descarregar pdf Manual de serviço para Recetor para automóvel Pioneer CDX-P670. Pioneer CDX-P670 50 páginas. Multi-compact disc player
Também para Pioneer CDX-P670: Manual do Proprietário (4 páginas), Manual do Proprietário (4 páginas), Manual do Proprietário (4 páginas), Manual do Proprietário (17 páginas), Manual de serviço (50 páginas)

Imprimir página

CDX-P670

6.2 CHECKING THE GRATING

- Checking the Grating After Changing the Pickup Unit

• Note :

CD mechanism modules the grating angle of the pickup unit cannot be adjusted after the pickup unit is changed.

The pickup unit in the CD mechanism module is adjusted on the production line to match the CD mechanism

module and is thus the best adjusted pickup unit for the CD mechanism module. Changing the pickup unit is thus

best considered as a last resort. However, if the pickup unit must be changed, the grating should be checked

using the procedure below.

• Purpose :

To check that the grating is within an acceptable range.

• Symptoms of Mal-adjustment :

If the grating is off by a large amount symptoms such as being unable to close tracking, being unable to perform

track search operations, or track searching taking a long time, may appear.

• Method :

• Measuring Equipment

• Measuring Points

• Disc

• Mode

CD CORE UNIT

• Checking Procedure

1. Enter Test mode, then select Multi-CD player and switch the 5V regulator on.

2. Using the TRK+ and TRK- buttons, move the pickup unit to the innermost track.

3. Press key 9 to close focus, the display should read "91". Press key 9 2 times. Enter Rough Servo mode. Press key

8 to implement the tracking balance adjustment the display should now read "81".

4. As shown in the diagram above, monitor the LPF outputs using the oscilloscope and check that the phase differ-

ence is within 75° . Refer to the photographs supplied to determine the phase angle.

5. If the phase difference is determined to be greater than 75° try changing the pickup unit to see if there is any

improvement. If, after trying this a number of times, the grating angle does not become less than 75° then the

mechanism should be judged to be at fault.

• Note

Because of eccentricity in the disc and a slight misalignment of the clamping center the grating waveform may be

seen to "wobble" ( the phase difference changes as the disc rotates). The angle specified above indicates the aver-

age angle.

• Hint

Change the disc changes the clamp position and may decrease the "wobble".

• Oscilloscope, Two L.P.F.

• E, F, REFO

• ABEX TCD-784

• TEST MODE

L.P.F.

100kΩ

390pF

REFO

100kΩ

390pF

Ych

Xch

Oscilloscope

L.P.F.