Pioneer Super Tuner IIID+ AVH-P7800DVD Manual de instalação - Página 16
Procurar online ou descarregar pdf Manual de instalação para Recetor para automóvel Pioneer Super Tuner IIID+ AVH-P7800DVD. Pioneer Super Tuner IIID+ AVH-P7800DVD 38 páginas. Owner's manual
Também para Pioneer Super Tuner IIID+ AVH-P7800DVD: Manual do Proprietário (34 páginas), Manual de instalação (42 páginas)
Imprimir página
Installation
Note:
• Before making a final installation of the unit,
temporarily connect the wiring to confirm that the
connections are correct and the system works
properly.
• Use only the parts included with the unit to
ensure proper installation. The use of unautho-
rized parts can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the dri-
ver's way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
• Do not place the display in a position where it
will impede the driver's visibility or affect the
operation of your vehicle's air bags.
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere hot
— for instance, near a heater outlet.
• If installation angle exceeds 30° from horizontal,
the unit might not give its optimum performance.
(Fig. 9)
• The cords must not cover up the area shown in
the figure below. This is necessary to allow the
amplifires to radiate freely. (Fig. 10)
Do not close this area.
• When installing make sure you leave ample space
(approx. 10 cm) in front of the exhaust fan outlet.
• When mounting the hide-away unit, make sure
none of the leads are trapped between the hide-
away unit and the surrounding metalwork or fit-
tings.
15
• Do not mount the hide-away unit near the heater
outlet, where it would be affected by heat, or near
the doors, where rainwater might splash onto it.
• Before drilling any mounting holes always check
behind where you want to drill the holes. Do not
drill into the gas line, brake line, electrical wiring
or other important parts.
• If the hide-away unit is installed in the passenger
compartment, anchor it securely so it does not
break free while the car is moving, and cause
injury or an accident.
• If the hide-away unit is installed under a front
seat, make sure it does not obstruct seat move-
ment. Route all leads and cords carefully around
the sliding mechanism so they do not get caught
or pinched in the mechanism and cause a short
circuit.
• Follow the instructions below when installing the
power supply box.
-Keep the power supply box as far away as possi-
ble from any antenna cable.
-Do not install the power supply box where it
might obstruct safe driving.
Installing the hide-away unit
Mounting with Brackets
30°
Fig. 9
Car mat or chassis
Fig. 10
Tapping screw
(4 × 12 mm)
Bracket
Drill 2 to 2.5 mm
diameter holes.
Screw
(4 × 8 mm)
Fig. 11