Pioneer XC-L7 Manual de Instruções - Página 49

Procurar online ou descarregar pdf Manual de Instruções para Recetor para automóvel Pioneer XC-L7. Pioneer XC-L7 50 páginas. Stereo cd receiver/stereo cassette deck/ speaker system

Imprimir página

Timer doesn't operate.

@ Clock isn't set to the correct current

time.

Power interruption has caused the

clack to be set to the incorrect time

{when display is flashing).

Remote control unit

Batteries are exhausted.

doesn't work.

A fluorescent lamp is located close

to the remote control unit.

The remote control unit is not pointed

at the signal receiver on the display

unit.

Power won't turn on to

System cable connection is incorrect.

the deck or CD receiver.

e@ Reset the clack to the correct current

time. (= P. 15)

Reset the clock to the correct current

time, (se P. 15)

Load new batteries.

Remove the fiuorescent lamp from

the area of the remote control unit.

Point the remote contro! unit at the

remote sensor (located on the right

side of the display unit) when oper-

ating.

Connect the system cable correctly.

When the system is installed near a television set, magnetic influence from the speakers may cause the televi-

sion's picture to be distorted. This symptom frequently occurs when using an indoor antenna; in this event,

install an outdoor antenna, or separate the system farther from the television.

Static electricity and other outside electrical influences may cause the system to operate incorrectly. in such

cases, unplugging and reconnecting the power cord may help correct the problem.

More than one of the same kind of component (CD receiver, MD recorder, or cassette deck) cannot be con-

nected at the same time.

NOTE:

Setting the tuner's frequency interval

FM broadcasts are normally tuned at 50kHz intervals

and AM broadcasts at 9kHz intervals, but this setting

can be changed to 100kHz (FM) and 10kHz (AM) if de-

sired in the following way:

1. Turn the power off.

2. While holding the CD receiver's STOP button de-

pressed, press the display unit's STANDBY/ON but-

ton to ON.

Repeat the above steps to return the tuner's frequency

interval to its original setting.