Pioneer AVH-5200BT Manual de operação - Página 7

Procurar online ou descarregar pdf Manual de operação para Recetor Pioneer AVH-5200BT. Pioneer AVH-5200BT 20 páginas. Dvd rds av receiver
Também para Pioneer AVH-5200BT: Manual de início rápido (2 páginas)

Imprimir página

Before You Start

! You can turn off the warning tone. Refer to

Switching the warning tone on page 50.

Important

! Handle gently when removing or attaching

the front panel.

! Avoid subjecting the front panel to excessive

shock.

! Keep the front panel out of direct sunlight and

high temperatures.

! If removed, replace the front panel on the unit

before starting up your vehicle.

Removing the front panel

% Pinch the top and bottom of its right

side and pull the front panel out.

Take care not pinch it too tightly or to drop it,

and also avoid contact with water or other

fluids to prevent permanent damage.

Re-attaching the front panel

Slide the front panel to the left.

Front panel and the head unit are connected

on the left side. Make sure that the front panel

has been properly connected to the head unit.

Press the right side of the front panel

until it is firmly seated.

# If you can't attach the front panel to the head

unit successfully, try again. However, forcing the

front panel into place may result in damage.

Resetting the microprocessor

By pressing RESET, you can reset the micro-

processor to its initial settings without chan-

ging the bookmark information.

The microprocessor must be reset in the fol-

lowing situations:

! Before using this unit for the first time after

installation

! If the unit fails to operate properly

! When strange or incorrect messages ap-

pear on the display

Turn the ignition switch OFF.

Press RESET with a pen tip or other

pointed instrument.

For this function, verify the following section

before operation. Refer to this page.

RESET button

Note

Switch your engine ON or set the ignition switch

to ACC ON before pressing RESET in the follow-

ing situations:

! After completing connections

! When erasing all stored settings

! When resetting the unit to its initial (factory)

settings

Section