Pioneer DEH-P7400HD Manual do Proprietário - Página 6

Procurar online ou descarregar pdf Manual do Proprietário para Recetor Pioneer DEH-P7400HD. Pioneer DEH-P7400HD 39 páginas. Cd rds receiver

Imprimir página

Pioneer DEH-P7400HD Manual do Proprietário

Section

Operating this unit

Removing the front panel to protect your unit from

theft

1 Press the detach button to release the front

panel.

2 Push the front panel upward (M) and then pull

it toward (N) you.

3 Always keep the detached front panel in a pro-

tection device such as a protection case.

Re-attaching the front panel

1 Slide the front panel to the left.

Make sure to insert the tabs on the left side of

the head unit into the slots on the front panel.

2 Press the right side of the front panel until it is

firmly seated.

If you cannot attach the front panel to the

head unit successfully, make sure that you are

placing the front panel onto the head unit cor-

rectly. Forcing the front panel into place may

result in damage to the front panel or head

unit.

Turning the unit on

1 Press SRC/OFF to turn the unit on.

Turning the unit off

1 Press and hold SRC/OFF until the unit turns

off.

Selecting a source

1 Press SRC/OFF to cycle between:

XM (XM tuner)—SIRIUS (SIRIUS tuner)—

TUNER (tuner)—CD (CD player)—USB (USB

storage device)/iPod (iPod connected using

USB input)—Pandora (Pandora)—EXT (exter-

nal unit 1)—EXT (external unit 2)—AUX1

(AUX1)—AUX2 (AUX2)—BT Audio (BT audio)

—TEL (BT telephone)

Adjusting the volume

1 Turn M.C. to adjust the volume.

CAUTION

For safety reasons, park your vehicle when re-

moving the front panel.

Notes

! When this unit's blue/white lead is con-

nected to the vehicle's auto-antenna relay

control terminal, the vehicle's antenna ex-

tends when this unit's source is turned on.

To retract the antenna, turn the source off.

! If plug and play is on and either an iPhone or

iPod touch is connected, it may take time for

your source to switch. Refer to

USB plug&play (plug and play) on page 15.

! TEL (BT telephone) is available on DEH-

P7400HD only when a Bluetooth adapter (e.

g. CD-BTB200) is connected to the unit.

Operating this unit

Use and care of the remote

control

Using the remote control

1 Point the remote control in the direction of the

front panel to operate.

When using for the first time, pull out the film

protruding from the tray.

Replacing the battery

1 Slide the tray out on the back of the remote

control.

2 Insert the battery with the plus (+) and minus

(–) poles aligned properly.

WARNING

! Keep the battery out of the reach of children.

Should the battery be swallowed, consult a

doctor immediately.

! Batteries (battery pack or batteries installed)

must not be exposed to excessive heat such

as sunshine, fire or the like.

CAUTION

! Use one CR2025 (3 V) lithium battery.

! Remove the battery if the remote control is

not used for a month or longer.

! There is a danger of explosion if the battery is

incorrectly replaced. Replace only with the

same or equivalent type.

! Do not handle the battery with metallic tools.

! Do not store the battery with metallic ob-

jects.

! If the battery leaks, wipe the remote control

completely clean and install a new battery.

! When disposing of used batteries, comply

with governmental regulations or environ-

mental public institutions' rules that apply in

your country/area.

! "Perchlorate Material – special handling may

apply.

See www.dtsc.ca.gov/hazardouswaste/

perchlorate. (Applicable to California,

U.S.A.)"

Important

! Do not store the remote control in high tem-

peratures or direct sunlight.

! The remote control may not function properly

in direct sunlight.

! Do not let the remote control fall onto the

floor, where it may become jammed under

the brake or accelerator pedal.

Menu operations identical

for function settings/audio

adjustments/initial settings/

lists

Returning to the previous display

Returning to the previous list/category. (the folder/

category one level higher.)

1 Press

/DISP.

Turning the demo display on or off

1 Press and hold

/DISP.

Returning to the ordinary display

Canceling the initial setting menu

1 Press BAND/ .

Returning to the ordinary display from the list/cat-

egory

1 Press BAND/ .

Selecting a function or list

1 Turn M.C. or LEVER.

! In this manual, "Turn M.C." is used to describe

the operation used to select a function or list.