Pioneer X-HM50-K Manual de Instruções - Página 24

Procurar online ou descarregar pdf Manual de Instruções para Recetor Pioneer X-HM50-K. Pioneer X-HM50-K 28 páginas. Cd receiver system

Imprimir página

Enhancing your system

The connection lead is not included. Purchase a

commercially available lead as shown below.

STANDBY/ON

TIMER

INPUT

PHONES

AUDIO IN

USB

PHONES

Audio cable (not supplied)

Listening to the playback sounds of

portable audio player, etc.

Use a connection lead to connect the portable

audio player etc. to the AUDIO IN socket.

When using video equipment, connect the audio

output to this unit and the video output to a

television.

Press the STANDBY/ON button to turn the power on.

Press the AUDIO/LINE (INPUT) button on the

remote control or INPUT button repeatedly on main

unit to select AUDIO IN function.

Play the connected equipment.

If volume level of the connected device is too high,

sound distortion may occur. Should this happen,

lower the volume of the connected device. If volume

level is too low, increase the volume of the connected

device.

Note

To prevent noise interference, place the unit away from

the television.

Headphones

• Do not turn the volume on to full at switch on and

listen to music at moderate levels. Excessive sound

pressure from earphones and headphones can

cause hearing loss.

• Before plugging in or unplugging the headphone,

reduce the volume.

• Be sure your headphone has a 3.5 mm diameter

plug and impedance between 16 and 50 ohms. The

recommended impedance is 32 ohms.

• Plugging in the headphone disconnects the

speakers automatically. Adjust the volume using the

VOLUME control.

• Audio from the iPod/iPhone cannot be heard via the

headphones connected to the unit. "

" will be displayed if you connect the headphones

when the iPod/iPhone function is selected.

VOLUME

X-HM50

AUDIO IN

USB

Portable audio

player, etc.

Not Support

Troubleshooting chart

Many potential problems can be resolved by the owner

without calling a service technician.

If something is wrong with this product, check the

following before calling your authorized PIONEER

dealer or service centre.

General

Symptom

• The clock is not set

to the correct time.

• When a button is

pressed, the unit

does not respond.

• No sound is heard.

CD player

Symptom

• Playback does not

start.

• Playback stops in

the middle or is not

performed properly.

• Playback sounds

are skipped, or

stopped in the

middle of a track.

Remote control

Symptom

• The remote control

does not operate.

Possible cause

• Did a power failure

occur?

• Reset the clock. (Refer

page 9)

• Set the unit to the power

stand-by mode and then

turn it back on.

• If the unit still

malfunctions, reset it.

(Refer page 24)

• Is the volume level set to

"Min"?

• Are the headphones

connected?

• Are the speaker wires

disconnected?

Possible cause

• Is the disc loaded upside

down?

• Does the disc satisfy the

standards?

• Is the disc distorted or

scratched?

• Is the unit located near

excessive vibrations?

• Is the disc very dirty?

• Has condensation

formed inside the unit?

Possible cause

• Is the AC power lead of

the unit plugged in?

• Is the battery polarity

correct?

• Are the batteries dead?

• Is the distance or angle

incorrect?

• Does the remote control

sensor receive strong

light?