Pioneer VSX-9500S VSX-7500S Manual de Instruções - Página 43

Procurar online ou descarregar pdf Manual de Instruções para Recetor estéreo Pioneer VSX-9500S VSX-7500S. Pioneer VSX-9500S VSX-7500S 48 páginas.
Também para Pioneer VSX-9500S VSX-7500S: Manual de Instruções (48 páginas)

Imprimir página

Pioneer VSX-9500S VSX-7500S Manual de Instruções

REMOTE

CONTROL

PROGRAMMING

)

GD) LEARN indicator

This indicator lights when the Learr: function is activated

ON: Learning is possible.

OFF: Regular remote control functions can be performed

NOTE: If the LEARN indicator flashes, this indicates that the program

capacity is exceeded and that the last command

is not memorized.

(2) LEARN selector switch

This can be set as follows:

LEARN:

This position is used for staring the codes of your remote control unit

USE:

Set to this position atter codes have been stored in the LEARN position

(Set to this position when using memorized commands.)

SR RECALL:

Set to this position when transmitting Pioneer unified remote control

code signals (Marked on the remote control unit)

[Operation example}

1. Set the LLARN switch of the programmable remote control unit to

the LEARN position and set the TRANSMIT mode selector switch

to the VIDEO position,

Place the transmission sections of the programmable remote control

unit and the remote control of the VCR facing each other.

7 to 2 inches

ae ue vale wht

WGI

1b ale a

BU BRU

EREG Ub UM

WP 10 6 8 ure ook ON tH

(Lo Labae

ae oopane

« Place the two units on a table, separated by 2 to 5 cm (1 to 2

inches}

Memorization will not be possible if they are too close,

3. Hold down the VCR PLAY key of the Programmable remote control

unit until the LEARN indicator light up, then release the key.

4. Hold down the PLAY key of the VCR remote control unit.

Release the key of the VCR remote control unit after making sure

that the LEARN indicator has gone out on the Pioneer remote control

unit.

NOTE:

if the LEARN indicator flashes, it indicates that you are trying to preset

a key not available for the learning function, or otherwise the program

capacity has been exceeded, the function programmed last will not be

memorized correctly. Ail previously programmed functions, however,

will be retained in memory and may be used as they are if the last

function

is not

essential.

For re-programming

refer to page

"Returning to the Initial Settings."

6. Set the LEARN selector switch of the programmable remote contro!

unit to the USE position.

* The previous code (Pioneer uniform remote control code or code

for other equipment) is erased and replaced by the new code.

7. Check that the program works.

* Try actual operation and make sure the unit works properly.

* If the VCR does not operate when pressing the key, change angle,

position and distance between the remote control units and repeat

the programming procedure.

* When programming, make sure that the function indications (for

example,

2» , >,

MH) on the other remote contro! unit and the

programmable remote control unit are the same. This will facilitate

operation.

NOTE:

Be careful when using the fearn function because signals from the

transmitting remote control unit may be reflected from walls or the

ceiling, and may arrive at the sensor of a component other than the

programmable remote control unit. It's a good idea to remave the tape

from a cassette deck or VCR in case they are accidentally activated.

it is also preferable to unplug the power cords of system components

from power outlets, or cover the remote sensars of remote controlled

components

to prevent accidental operation.