Pioneer A-40AE Manual de instruções - Página 9

Procurar online ou descarregar pdf Manual de instruções para Amplificador Pioneer A-40AE. Pioneer A-40AE 24 páginas.

Connecting 2 speaker systems

a Speaker Cable

3/8"

(10 mm)

You can connect another speaker system set to the

SPEAKERS B jacks.

0 You can output the same audio as Speaker A System by

switching with A/B/A+B. Press SPEAKERS on the main

unit to switch. The selection changes in the order

SPEAKERS A, SPEAKERS B, SPEAKERS A+B with

each press. Refer to "Switching speaker output" (p17)

for details.

(Note) Speaker Impedance

∫ When outputting audio simultaneously from 2

speaker systems

Connect speakers with an impedance of 8 ≠ to 32 ≠.

0 Setup: You have to change the setting on this unit if any

of the connected speakers have 8 ≠ or more to less than

16 ≠ impedance. Change the speaker impedance setting

to 4 ≠. (p15)

∫ When switching to either A or B for audio

output

Connect speakers with an impedance of 4 ≠ to 16 ≠.

0 Setup: You have to change the setting on this unit if any

of the connected speakers have 4 ≠ or more to less than

8 ≠ impedance. Change the speaker impedance setting

to 4 ≠. (p15)

Right

Left

Right

Speakers A

Connect the Speaker Cables

Make correct connection between the unit's jacks and

speaker's jacks (+ side to + side, and - side to - side) for

each channel. If the connection is wrong, a bass sound will

not be reproduced properly due to reverse phase. Twist the

wires exposed from the tip of the speaker cable so that the

wires do not stick out of the speaker terminal when

connecting. If the exposed wires touch the rear panel, or the

+ side and - side wires touch each other, the protection

circuit will be activated.

Preparations

Left

Speakers B